Alcohol warning



#2

I believe you need to be careful when using alcohol around sesitive electronic circuits.
Alcohol, I believe as well as water is a polar molecule and could effectively make high impedence connections to various circuits. Make sure that you dry out the calculator (evaporate the cleaning liquids) before turning on the calc.


#3

Alcohol may be polar, but it sure isn't ionic, which is what really causes some liquids (including impure water) to conduct.
I've just measured the resistance of some propan-2-ol. With about 1/4" depth in a container and a couple of probes about 1/4" apart, I was getting resistances of the order of 20M Ohms.
So I think the resistance of the remaining film of alcohol after cleaning a calculator in it is not going to matter that much (most of the signals in an HP calculator come from
considerably lower impedance sources than that). I'd not want to keep the batteries in while cleaning it, but
if you take the batteries out, wash the calculator (or the boards, or whatever) in propan-2-ol, leave it for a few minutes to dry (it evapourates fast), it should be OK. Even if you leave the batteries in, I would be very suprised if it did any permanent damage.
Incidentally, propan-2-ol is generally recomended for cleaning PCBs, precision mechanical parts, and so on.
One warning, though. It doesn't attack much, but it can cloud up some optical plastics, which may have been used for lenses over LED displays. I'd not want to soak such a device with propan-2-ol. But apart from that, there's no problem that I've ever found.
It is certainly a lot better than the contact cleaner/lubricants that are sold. And I don't even want to attempt to compare it to WD40 :-)....

#4

Isopropyl alcohol is a standard cleaning solvent used in the electronics industry for decades. There is no problem with it leaving conductive residue. It can cloud plastics particularly in its conventrated forms.

I use cigarette lighter fluid to clean adhesive residue off of cases without any problems. It is also used with red jewlers rouge to polish scratches out of the red LED lenses. Always test a new solvent on an inconspicuous place when it doubt.

Propanalol is a standard ingredient in most lens cleaning solutions and I have never had a problem with it attacking plastics. It is a rather gentle solvent.

#5

It depends from the kind of alcohol. It seems that beer and gin tonic are not the right ones for electronic circuits, but you can test them on texas instruments calcs !


#6

No, not gin or vodka :-). The stuff I use comes in a spray can labelled 'IPA' (Iso Propyl Alcohol, which is the old name for propan-2-ol), and
claims to be 99.7% propan-2-ol. I've used it on a lot of electronic, mechanical and optical parts (I repair a lot more than just HP calculators :-)), and
it's never done any damage. It does seem to be safe on at least some HP stuff too, for example it's what I use to
clean the interboard contacts in HP41s.

#7

I can vouch for the baddness of beer in/on/saturating/electronics...I can also say that the next day, a little more level-headed, Isopropyl alcohol does wonders. For the device, NOT for your head!!!!

#8

I prefer testing beer and gin tonic by drinking it. Unfortunately, normally there's no alcohol left after I found it suitable ... :-(


Possibly Related Threads...
Thread Author Replies Views Last Post
  [HP-Prime CAS] "Warning, ^ (Command) Is ambiguous on non square matrices"?? CompSystems 1 905 12-07-2013, 07:15 PM
Last Post: CompSystems
  Flash Flood Warning: 9/16/2013 (One Week from HHC13) Eddie W. Shore 8 1,339 09-17-2013, 09:20 PM
Last Post: Craig Ruff
  Low power warning for HP-15C LE and batteries Nick_S 1 642 09-16-2013, 09:34 AM
Last Post: Hans Brueggemann
  Warning - Don't update RPN-67 Pro on your iPad Michael de Estrada 9 1,207 05-02-2013, 03:21 PM
Last Post: BShoring
  Warning: These are NOT Clonix! Diego Diaz 11 1,402 03-02-2013, 01:15 PM
Last Post: Diego Diaz
  Warning if you have a calculator shipped outside the US. No warranty. Jim Creybohm 8 1,027 10-11-2011, 08:46 AM
Last Post: Eddie W. Shore
  Immersing in alcohol David Ramsey 21 2,282 08-30-2011, 03:50 AM
Last Post: snaggs
  HP 10BII+ Battery removal warning Jim Yohe 19 2,118 04-24-2011, 09:52 AM
Last Post: Eddie W. Shore
  Warning regarding a TAS auction Michael de Estrada 10 1,096 06-24-2010, 10:22 AM
Last Post: bill platt
  Warning: GRiD cards ad for 48GX Richard Reed 3 601 10-04-2009, 08:42 PM
Last Post: Richard Reed

Forum Jump: