Posts: 4,027
Threads: 172
Joined: Aug 2005
Hey, Diego;
thanks for your comments. My pleasure, believe me.
Once I am not the one who made the wonders, supporting them (both the wonders and those who created them) is also part of the fun. More than being a pleasant activity, suporting guys like you, Meindert, Hrast and other developpers is a priviledge. Besides, developping HW and SW for these calculators is a daring activity by itself, though.
In time: instead of bending the tinny terminals, would that be possible to add a thin PCB cut to solder the contacts? Just came to my mind...
Cheers.
Luiz (Brazil)
Edited: 22 Jan 2006, 6:34 p.m.
Posts: 11
Threads: 7
Joined: Jan 1970
Hi,
I have just finished the module today.
Works fine.
Managed to fit pcb without altering the connector pins!
I am using a two terminal resonator at 12MHz, module did not work at first, I suspected the oscillator was not operating. I added two 33pF capacitors either side of the resonator connected to ground.
This now works.
I have not made the programming adaptor yet, I pre-programmed the 18LF252 in an external programmer first.
I am using the ClonixLP version of the code.
I have modified the Configuration Build Utility under Visual C++ to support the ClonixLP code rather than the Clonix6 code.
I look forward to any new versions of the code.
Thanks for your help.
Regards
Phil Green