HP 9825A



#6

Hello everybody!
I have got the following problem. I want to (exactly my boss wants me to) connect an HP 550C-printer to an HP 9825A. The manual gives me the pin names and I found a table of the official parallel-port settings.
My problem is that I don't know the meanings of "HLT", FLG", "On Cover" and so on and can not say which pins have to be connected. Does anyone have an idea and/or experience in this topic?

Many thanks in advance!
Greetings, Stephan


#7

Do you have an HP98032 GPIO (16 bit parallel) interface module?

The I/O slots at the back of the 9825 are essentially the processor I/O bus, and certainly can't be directly connected to the printer.

If you don't have the interface, I would seriously recomend looking at the operation/service manual for it (it's on the MoHPC CD-ROMs, I think). That will give you some idea of the circuitry required.

If you do have the interface, I'll look in the manual and see if I can work out how to link it to a normal Centronics port.

#8

What kind of adapters do you have for your 9825? (E.g. the GPIO card that Tony suggested, but also HP-IB would also be OK).

**vp


#9

Thanks a lot!
There is an interface card and someone else hase already connected some cables to the centronics port. After starting the print job, the printer says 'busy', but nothing else happens. The original printer belonging to the calculator had the cover on function, I put it on ground (it is not[cover on]), I did the same with the not[ready] pin. Do you know something about problems with the timing for the handshake and so on? Is it just a standard parallel bus?

Thanks again!
Stephan


#10

Stephan wrote:
> There is an interface card

can you please tell us what is the part number of the 9825A interface card you are using?

BTW can you also tell us what is the configuration of the 9825A (ROMS, RAM etc.)

Best Regards

**vp


Possibly Related Threads...
Thread Author Replies Views Last Post
  Connecting a 9825A to the outside world David Ramsey 3 406 06-12-2013, 04:13 AM
Last Post: Tony Duell
  HP-9825A I/O David Ramsey 3 385 06-06-2013, 11:23 PM
Last Post: David Ramsey
  9825A use 9121 disk drive? David Ramsey 0 169 05-11-2011, 04:03 PM
Last Post: David Ramsey
  HP 9825A Tape driv Eugene Royer (USA) 8 535 07-21-2006, 04:04 PM
Last Post: Eugene Royer (USA)
  HP 9825A with DC 100A tapes Eugene Royer (USA) 5 406 06-09-2006, 01:09 PM
Last Post: Eugene Royer (USA)
  9825A: bad master clock Vassilis Prevelakis 15 812 05-30-2006, 10:33 AM
Last Post: David Smith
  Problems with an HP 9825A Fabrizio 1 205 01-08-2004, 11:11 AM
Last Post: Achim
  HP 9825A Scott 5 373 07-27-2003, 04:35 PM
Last Post: Mike
  9825A or B ROMs Olivier Croissant 7 417 05-05-2003, 01:30 AM
Last Post: olivier croissant
  hp 9825A Lee Jones 2 223 04-28-2003, 05:36 PM
Last Post: Tony Duell (UK)

Forum Jump: