HPIL-RS232 interface



#3

Hi everybody:

I have finally received my HPIL-RS232 interface. Following Emmanuel´s instructions I have connected it to the PC and I have tried HPILCOM. But I have some questions

1) I have been able to send a program to the PC using OUTP. However I see that I send all the programs that I have in the memory, not just the program which label I have in the ALPHA register

2)To get a program from the PC I have to press transmit in HPILCOM and then INP in the calculator(otherwise it doesn´t work and produces a "READ ERR"). Doing this I get the comunication, but all the programs in the calculator are replaced with the transmited information.

Any sugestion?

Thanks in advance

Jon


#4

hi jon, maybe it's not too difficult to fix.
1) OUTP only sends out the program which is specified in the alpha register. OUTP will then send all code from the specified global alpha label to the following END instruction. you should check whether you did a GTO.. after each program you keyed into the calc. if you did not, (i.e., you used STOP at the end of the program), then all programs are "chained" together and cannot be separated by OUTP. if you do a CAT1, you should always see an END between adjacent programs.

2) above said should also fix the second issue. please check the manual for the "GETP" routine, which automates the process of "INP"ing a program. by using "GETP", it is not necessary to do a "TRANSMIT" on HPILCOM. make sure that HPILCOM is not in "DUMB" mode.

plz do also check the documentation of the program for my e-mail address and drop me a line, if you have further questions.

hope, that helps!
cheers,
hans
1234

Edited: 13 Jan 2005, 1:39 p.m.


Possibly Related Threads...
Thread Author Replies Views Last Post
  HP48GX Interface to a PC John W Kercheval 7 842 09-29-2013, 10:53 AM
Last Post: John W Kercheval
  HP Prime "Symb" interface (bug?) Han 8 866 09-13-2013, 12:48 PM
Last Post: Chris Tvergard
  Hand Held Products RS232 to HP-IL aj04062 11 1,175 08-31-2013, 07:12 PM
Last Post: Paul Berger (Canada)
  Virtual HP-IL Video Interface ILVideo the 2nd! Christoph Giesselink 3 584 08-15-2013, 06:49 PM
Last Post: Sylvain Cote
  HP 85 Serial Interface; INPUT Example? inaki 1 410 06-12-2013, 11:09 PM
Last Post: Paul Berger (Canada)
  Virtual HP-IL 40 col. video interface simulation Christoph Giesselink 10 1,064 08-19-2012, 06:46 PM
Last Post: Richard Wagoner
  Cursors on Video Interface HP82163 Christoph Giesselink 4 570 07-21-2012, 02:57 PM
Last Post: Sylvain Cote
  HP75D with HPIL Karel Kupka 2 393 07-13-2012, 02:57 AM
Last Post: Karel Kupka
  41CL & EMU41 & IL2000 interface system Christoph Klug 0 254 03-22-2012, 05:23 PM
Last Post: Christoph Klug
  HP-IL SCSI Interface Richard Wagoner 15 1,296 02-19-2012, 07:39 PM
Last Post: Richard Wagoner

Forum Jump: