HP 01 calc/ watch repair



#2

After a list member graciously answered my question about how to setup the time for the HP-01, I found out that keypad is messed up. When I press any digit, I either get 3 (if I press the upper row) or 8 (if I press the lower one). Can someone help me with a place to repair the watch if one exists?

Thanks
Sam


#3

The news is not good: http://www.hpmuseum.org/cgi-sys/cgiwrap/hpmuseum/archv014.cgi?read=65455


#4

Alas, I have to agree with that. I had a chance to handle the module from an HP01 at the last HPCC meeting. It consists of 2 ceramic 'circuit boards' glued together, the keyboard contacts being on the top one. I believe that inside, there are the bare silicon dice (chips), bonded out (connected) by fine gold wires to traces on the lower 'board'. These chips are not in packages, there's not way to replace them even if you could get spares (and AFAIK they were only used in the HP01). The display, battery contacts, crystal and a couple of passive components are soldered to the back surface of the lower board and could, in theory, be replaced, but they're unlikely to fail anyway.

The 2 boards are connected by a zebra-strip like connector on the right edge, which can be pulled out. This sowuld be worth cleaning if some of the keys are totally dead.

To return to the orignal problem, if this had been a classic-series machine (related architecture), I would have suspected a C&T chip failure, or maybe ROM failure. But there's no way to replace those on the '01


#5

One may also try a trip through an ultrasonic cleaner (use three passes with fresh distilled water in each pass). Shake out as much water was possible and then let dry. I use an oven on LOW (<150 degrees F). The high impedence circuitry on the boards is easily messed up by any accumulated gunk.


Possibly Related Threads...
Thread Author Replies Views Last Post
  Last HP emulation, 32 & 01 Olivier De Smet 0 197 09-07-2013, 08:27 AM
Last Post: Olivier De Smet
  HP Prime - transferring between calc and PC Andy B (Australia) 3 307 08-15-2013, 05:29 PM
Last Post: Tim Wessman
  wp34s calc to calc communication Andrew Nikitin 1 272 07-29-2013, 01:57 AM
Last Post: Marcus von Cube, Germany
  Identify HP-01 Prototype parts aj04062 3 369 06-11-2013, 09:49 PM
Last Post: aj04062
  Stupid idea of the day: 41-compatible watch bhtooefr 0 196 03-31-2013, 08:23 AM
Last Post: bhtooefr
  HP Calc Series Mic 3 307 03-21-2013, 01:34 AM
Last Post: Mic
  Still a new colour calc ! When you'll make it HP ? Mic 10 625 01-13-2013, 09:17 AM
Last Post: Marcus von Cube, Germany
  HP calc case thermoplastic types Duane Hess 2 299 11-25-2012, 10:50 PM
Last Post: Paul Berger (Canada)
  Non HP very early LCD Calc? Ian Phillips 6 503 10-06-2012, 01:57 PM
Last Post: Frank Boehm (Germany)
  HP-01 Restoration aj04062 4 380 10-01-2012, 08:52 PM
Last Post: BobVA

Forum Jump: