Hello, I need help with my HP 97S. I got almoust the HP97S working again, but one issue is open. The I/O interface was disconnected from the calculator board and I need the pinout to reconnect it again, so which of the small little cable are to be connected to which pin on the circuit board. Please help if you can. I would like to thank everyone in advance for helping me out. Thanks very much !
HP 97S Please Help..
|
|
« Next Oldest | Next Newest »
|
▼ ▼
Post: #8
12-20-2004, 10:36 AM
If you have the CD/DVD manual set from this museum, there's a picture of the internal connection called: 97SINT.JPG that shows the connection in enough(?) detail to reconnect it. I think that this picture used to be on this web site, so perhaps Dave still has it in higher resolution if it's not quite good enough.
▼
Post: #9
12-20-2004, 10:44 AM
Thanks Katie for the fast reply. I only saw the photo from the 97S listed on the museum page. The problem is that each wire is connected below the red connector, so I am not able to determine which wire goes to which pin below this red cover. If there is another photo I do not have it. Thanks Dennis ! ▼
Post: #10
12-20-2004, 05:13 PM
Hi Dennis, I have a HP97S, so I could open it and take a picture next week (after Christmas when I have some time off. Let me know at that time if you still need it. Success Ronald
Post: #11
12-21-2004, 01:24 AM
I took a picture of the connector in my 97S and I think the order is: 1 - white/yellowand the larger diameter lead that connects outside of the 16-pin header Here's the picture: http://www.wass.net/pictures/97s.jpg -Katie
Edited: 21 Dec 2004, 1:26 a.m. ▼
Post: #12
12-21-2004, 05:19 AM
Hello Katie,
thanks very very much for your effort and time to help me out on this. Ronals, thanks also for your offer to help me, I think what Katie send out should be sufficient. Best greeting + thanks from germany Dennis |