My switch now turns the motor on OK when I insert a card, but I am having problems getting the card to feed properly.
I either have a situation where the motor works hard,a passes the card slowly, in which case I think my roller is too big, or the motor runs unevenly, in which case I think the roller is too small and is slipping.
I noticed that the nylon part of the motor clutch is broken in two, so I am not sure if the motor clutch is slipping, but when I take the motor out, and run it, and hold the worm gear, it doesn't seem to slip.
Is there any way I can eliminate all other causes and convince myself that it's just me roller making skills need honing ?. Can anyone sell/give me a roller that is known to work fine ?
I am yet to try the "fall through" test, perhaps someone can explain it to me ??
Thanks - John