Posts: 1,788
Threads: 36
Joined: Aug 2007
Your best bet is to carefully peel up the corners. I use a razor blade dipped in UnDu adhesive loosener. Try not to make a sharp fold in the corners or cut the label. Tiny fold lines are a lot better than the carnage left by trying to totally remove the label.
Posts: 27
Threads: 4
Joined: Jan 1970
You may want to try a technique that is used by Pinball
collectors to remove protective mylar films from pinball
playfields: Use freeze-spray (sold for cooling electronic
components), or regular canned-air (with the can held upside
down, the propellant comes out, giving the same effect as
freeze-spray). Thouroughly douse a section of the label,
and the freeze-spray will cause the adhesive to completely
separate from the label, and loose its adhesion. Carefully
lift up the first section of the label (using a credit card
or whatever to prevent it from sticking again), and continue
to work (liberally spraying) away from your starting point.
The glue will be left behind on the calc, and hopefully
the label will not get mangled (though I don't know if the
freeze-spray will affect the ink, since I've only worked
with mylar films which I intended to dispose of).
This really works, though it takes a bit of practice.
grant..
Posts: 20
Threads: 5
Joined: Jan 1970
Hello Andreas,
I've tried to reach you by e-mail but without no succes. I've done many card reader reparations for myself and others guys in Europe (many HP fans in Germany too...).
If you want I may send you some photos about the back label job before and after the card reader reparations.
You simply have to use the hair dryer to peel up the corners and then put them in place without adding new glue but using the existent...
Best regards :-)
Gian
http://www.hpcalculators.net
http://welcome.to/gian
p.s. remove dots after @ to reply