HP67 Card Reader Problem


I have a HP67 and the card reader is not working. I have found the problem is the little rubber roller is damaged due to aging.

I need to know where I can purchase the parts or subsitute with some kind of rubber tubing.



The original parts are no longer available. You can make replacements out of either tubing (R.C. aircraft fuel line or refrigerator water line) or with rubber O-Rings.

I have rebuilt a couple of these now and have used rubber O-Rings on both of them, with very good results. You can get the O-Rings at the local ACE hardware store for about 15 cents a piece, you will need two of them. The size that you want has an I.D. of 1/8" and an O.D. of 1/4". This is the perfect fit for these machines.

Just clean out all of the old gooey stuff and fit these onto the drive wheel. Be sure to read the article on HP-67 repair by Steve Loboyko on the repairs section of this site as it is full of good information. Good luck.


Possibly Related Threads...
Thread Author Replies Views Last Post
  Reasonable price for a 41C, Quad Mem, Time, Navigation and Card reader module? Eelco Rouw 10 2,321 12-12-2013, 01:52 AM
Last Post: Eelco Rouw
  hp-67 card reader problem. Marcel Samek 5 1,492 12-09-2013, 09:09 PM
Last Post: Paul Berger (Canada)
  HP67 eBay auction Cristian Arezzini 3 1,082 12-08-2013, 03:47 PM
Last Post: Raymond Del Tondo
  HP67/97 M.E. Pac cover Ignacio Sánchez 2 760 11-22-2013, 04:04 AM
Last Post: Ignacio Sánchez Reig
  HP-97 card reader pinch roller axle davorin 2 811 09-15-2013, 08:47 AM
Last Post: aj04062
  HP-97 Card Reader davorin 3 864 09-13-2013, 04:21 PM
Last Post: Stephan Matthys
  HP-67 Card Reader Repair Question aj04062 1 702 08-08-2013, 11:15 AM
Last Post: Randy
  Hp-67 card reader: tantalum capacitor identification Ignacio Sánchez 8 1,681 06-02-2013, 07:26 PM
Last Post: aj04062
  Testing card reader motor for 65 Michae Altmann 2 811 03-17-2013, 09:24 PM
Last Post: Randy
  Repaired HP-97 card reader doesn't show any signs of life jbssm 6 1,227 02-17-2013, 03:15 AM
Last Post: Alberto Fenini

Forum Jump: