Cardreader problem...



#2

I have a perplexing problem with a HP-67 cardreader: It reads and writes cards perfectly when running on battery alone but always errors on battery+charger. Ive changed chargers (the outputs are the same anyway). The motor voltage is within .1V between battery and battery and charger - this one has me beat at present so all ideas gratefully received.


#3

Are your nicads in good condition?

The problem could be caused by excessive ripple. The nicads are probably used in the 67 to both regulate and filter the rectified AC from the charger. (I say probably, because I'm not familiar with the 67, but that's how many other models do it)


#4

It sounds like his NiCads are fine since the card readers works on them without the charger. Have you tried another charger on it? I suspect something is wrong in it. Perhaps a bad filter cap or bad diode is letting AC ripple into the calculator.

Joe


Possibly Related Threads...
Thread Author Replies Views Last Post
  cheap power for the HP41C (while at desk with cardreader) exschr 3 322 05-06-2011, 02:29 PM
Last Post: Dieter
  HP 41 CX cardreader problem Matti Övermark 4 383 09-06-2008, 09:41 AM
Last Post: Matti Övermark
  Size of magnetic cards for cardreader Robert Graulich 6 512 12-09-2005, 09:40 AM
Last Post: Robert Graulich
  Cardreader behavior Stephan (CH) 8 556 11-08-2003, 05:36 AM
Last Post: Victor Koechli
  HP41CV cardreader Karel Marchena 1 204 10-14-2003, 12:40 PM
Last Post: David Smith
  HP67 magnetic-cardreader Harry 3 306 09-27-2003, 02:09 PM
Last Post: David Smith
  97 Card Reader Problem (NOT gummy problem) Peter Khor 5 420 10-04-2000, 11:03 AM
Last Post: ErikWahlin
  SW - HP41-Cardreader Sebastian Vries 9 654 05-25-2000, 12:28 AM
Last Post: Dave the "lostrabbit"
  Re: hp65 cardreader IC dead Joe 0 169 03-08-2000, 08:38 PM
Last Post: Joe
  HP82104A Cardreader-"G" ROM Info Peter Ohanessian 5 427 05-12-1999, 10:30 AM
Last Post: Peter Ohanessian

Forum Jump: