Stuck Omnibook 300 pop-out mouse. Ideas?



#2

Pushing the button moves the mouse a bit, but it does not come all the way out. It comes out perhaps a couple of millimeters. I can push it back in and hear the click, but...

Ideas of any easy way to fix that?


#3

If you have the OB in front of you on a flat surface, with the mouse button on top right position:

Press the button, then pull the mouse to the right until you see the plastic "lead". Push the mouse back into the hole, and start over a few times.

HTH

Ray


#4

How hard should I pull on the mouse when it has only come out 2-3 mm ?

I don't want to break it, but sounds like if I pull it too hard it will come out all the way and all would be ok, regardless.

So, push the button and pull pull pull until it comes out ?

#5

Raymond has described it perfectly. Several of my OB's have this sticking mouse problem also.

You'll want to move the mouse (once out of its hole) full left to right and full up and down - this will calibrate the mouse limits for windows.

Note: The mouse is full removable - just tug hard when it's full out and it'll pop out. You can just re-insert it and it'll pop back it. I've had to replace the mouse in one of my units this way when the mouse buttons quit working.

Bill


#6

Ok, so pulling on the Omnibook 300 mouse did get it pulled out, but here's what it looks like below.

The "glue" holding the three strips has come undone over time. I have carefully tried to get it back into the mouse cable slot, and it does make the cursor move on the screen, but has only left/right motion...no up down, which limits is utility as a mouse. :-)

Thoughts?


#7

Ok, I was afraid that it had delaminated - explains the jamming.

First, pop out the mouse from your OB-600 and try it in the 300 to ensure that everything works with a good mouse. Want to make sure nothing got damaged in the slot. The mice are interchangeable between the units.

If this works, then I think I have a spare mouse somewhere. I'll check to see if I can find it.

Bill


Possibly Related Threads...
Thread Author Replies Views Last Post
  [Prime] any ideas for a undo function? Stefan Dröge (Germany) 8 703 11-04-2013, 04:37 PM
Last Post: Damien
  Prime: Pedagoguery Software pop up banner Matt Kernal 1 331 10-20-2013, 01:54 AM
Last Post: Mic
  HP Prime MOUSE command SanS 3 420 10-15-2013, 12:15 PM
Last Post: Han
  [HP Prime] Request: re-execute history like CASIO classPAD serie 300/400 CompSystems 1 344 09-03-2013, 02:47 PM
Last Post: CompSystems
  HP41 Barcode ideas MichaelG 6 571 07-15-2013, 08:59 AM
Last Post: Olivier De Smet
  200LX problem: Insert batteries and get a continuous beep... ideas ? Gene Wright 8 722 06-19-2013, 04:52 PM
Last Post: gene wright
  HP 39gii Stuck Again! Eddie W. Shore 3 341 03-06-2013, 07:47 AM
Last Post: Eddie W. Shore
  50G ideas BD 56 3,552 08-16-2012, 11:23 PM
Last Post: Guy Dufour
  Omnibook 300 battery cells Dave Britten 5 534 08-15-2012, 11:54 AM
Last Post: Massimo Gnerucci (Italy)
  Single Level X^2 for HP-35...Any ideas Matt Agajanian 0 235 08-11-2012, 10:01 PM
Last Post: Matt Agajanian

Forum Jump: