How does the HP-97 printer paper feed work?



#2

I have started repairing the HP-97 I mentioned a bit further down. I have a problem with the printer. The paper feed does need a little help by pulling the paper manually. I have taken it appart and all the gears (at least all three I can see) are ok. And the head moves as it should. But I do not understand how the paperfeed works? Can anyone help?

Also, I have replaced the gumy wheel and the cardreader pulls the card through fine. But I get an error when trying to read a card. Not sure if it is the reading or the writing that is the problem. Should it be able to read cards written by an HP-67? In that case, I suspect reading doesn't work. Any thoughts on what to check?

Cheers,
Harald


#3

OK, I have worked out how it is supposed to work. I think it is just the rubber wheels that have hardened. How do I replace them? And what with? Has anyone done this yet?

Edited: 30 Mar 2012, 7:49 p.m.


#4

Hi Harald,

I have did the job in this mode, take a look at the following.
slideshow.

The silicon o-ring are 8x2 mm (OD=8;ID=4).

Let me know if it's quite understandable.

Regards

Ignazio

Edited: 31 Mar 2012, 3:33 a.m.


#5

Thanks for that! Seems like a good solution. However I wasn't prepared to take drastic measures yet. Insted I tried to scrape the hardened surface off the rubber wheels, and had a bit of succes. The paper is beeing pulled through now, but not quite straight. Maybe I can improve on that. If not, I'll try your approach.

Cheers,
Harald

#6

For what regards the card reader issue I remember that I read with a 97 a card written by a 67!
Regards


#7

Thank you! I just found that out myself,^too. The cardreader is now working! Somebody had messed about with the adjustment of the spring contacts and then used a bit of tape to jack up the PCB. I had removed that tape when doing the repair, but not re-adjusted the contacts. Now that I have done that, it is working!


Possibly Related Threads...
Thread Author Replies Views Last Post
  PIL-box w/o IL cable = paper weight Joe Horn 15 716 11-26-2013, 01:05 AM
Last Post: Les Wright
  HP-97 Printer Malfunction Dan Lewis 17 648 11-25-2013, 10:18 AM
Last Post: Thomas Chrapkiewicz
  emu48 - copy stack doesn't work (as expected) Thomas Radtke 2 273 11-11-2013, 02:19 PM
Last Post: Thomas Radtke
  Another Prime mystery - templates don't work anymore Michael de Estrada 2 208 11-02-2013, 11:34 AM
Last Post: Michael de Estrada
  HP-97 Printer Troubleshooting aj04062 6 391 10-15-2013, 08:45 PM
Last Post: Eric Smith
  Does the HP Prime software only work with Win 7/ 8 ? Michael de Estrada 3 263 10-12-2013, 02:52 PM
Last Post: John Ioannidis
  Back to School/Work/Other Calculator Poll Eddie W. Shore 63 2,857 09-12-2013, 06:03 AM
Last Post: bhtooefr
  HP-97 Printer Head aj04062 1 181 09-11-2013, 09:18 PM
Last Post: Randy
  HP-97 Printer Head aj04062 0 129 09-10-2013, 09:19 PM
Last Post: aj04062
  HP-97 Printer parts davorin 5 314 08-29-2013, 02:10 AM
Last Post: Benoit Maag

Forum Jump: