Unable to clear HP-41cv MEMORY LOST error



#5

Can't seem to clear the MEMORY LOST message despite doing what the manual says....

I just bought an HP-41cv, since I liked it many years ago. There were batteries installed, but incorrectly, and some were starting to leak just a bit. No damage, no acid on the terminals or springs.

However, when I put new batteries the display immediately shows MEMORY LOST without even pressing ON. Further, I cannot clear the error no matter what. I've tried pressing CLX and ON while inserting the batteries, but no luck. Occasionally when I put the batteries in, the display is very faded, but immediately becomes crisp MEMORY LOST when I press a key (keypad is working then??).

Can anyone advise? I have only a couple days to determine if it'll work or I should return it for a refund.

Thanks!


#6

Search the Forum (don't forget the archives!) for Memory Lost and other 41C hangups, there are a lot of threads on the general subject. Solutions include various keyboard resets and completely discharging the internal storage capacitor (the one that allows you to change batteries without losing memory). My experience is very limited but I recently got a 41CX with quite dead batteries that wouldn't do or say anything with fresh batteries. After reading about discharging the capacitor, I used an ammeter to short the two outermost battery terminals (so I could see if any discharging was taking place). I had measured about a volt there with a high impedance voltmeter. With the ammeter I measured a current in the .1 to 1 milliamp range that dropped very slowly for a few minutes then stopped dropping at about 20 to 100 microamps (I forget exactly). Then after about 10 or 15 minutes, the current started dropping again and in a few minutes it was too low to measure, so I stopped. (I was hoping to avoid having to open the case and short out the capacitor directly, as there are some (or a) diode(s) between the battery terminals and the capacitor - some people report leaving the battery terminals shorted for ages before the calculator will respond.) In any case, I was lucky and after what I have described, the calculator started up correctly and continues to work fine. I know yours is stuck saying "MEMORY LOST" but it could still be because some illogical information is in the RAM - partially good information that is corrupted from an extemely low (but non-zero) supply voltage.

Good luck!

#7

With mine, it says MEMORY LOST the moment the batteries hit the terminals. Mostly I've read about resetting the calculator when it refuses to turn on. With mine, I've lost control immediately.

I've tried leaving the batteries out for a long period of time. I will try shorting the terminals next. Just doing it for a minute didn't change anything.

Does anyone know if this indicates a memory defect? I have to decide in the next couple of days whether this calc is going to work before my return window disappears.

#8

HP41 manuals actually say to put the batteries in backwards for a while to hasten the discharge. There is a protection diode that keeps the full reverse voltage out of the machine, and the 0.7 volt reverse drop will not hurt anything. I have HP41 machines (especially CV and CX) that will retain their memory for over a month without batteries.

Another very likely cause of your problem is dirty internal contacts. The zebra connector between the CPU and keyboard in fullnut machines is partiularly prone to cause this problem. Also the battery contact assembly. Also caused by spilled gunk on the keyboard traces.


Possibly Related Threads…
Thread Author Replies Views Last Post
  AFTER HP-Prime update, AA1000 DOES NOT CLEAR THE SPREADSHEET Joseph Ec 0 1,526 12-06-2013, 11:28 PM
Last Post: Joseph Ec
  AFTER HP-Prime update, AA1000 DOES NOT CLEAR THE SPREADSHED Joseph Ec 0 1,401 12-06-2013, 12:19 PM
Last Post: Joseph Ec
  [HP Prime] "Error while checking exact value with approximate value, returning both!" Chris Pem10 13 5,167 12-06-2013, 05:12 AM
Last Post: parisse
  HP 41CV Repairs William Mabotja 3 1,655 11-20-2013, 04:45 PM
Last Post: Mike Powell
  How to clear x Michael Carey 15 4,537 11-19-2013, 12:55 PM
Last Post: Michael de Estrada
  More Prime problems - lost Apps key again Michael de Estrada 10 3,153 11-16-2013, 12:46 PM
Last Post: Michael de Estrada
  MS advert shows spreadsheet with obvious error BruceH 3 2,241 11-14-2013, 09:50 AM
Last Post: Bill (Smithville, NJ)
  Unable to reassign K_Abc (a b/c) key Andy Gryc 1 1,225 11-09-2013, 05:02 PM
Last Post: Han
  "Packing" syndrome of my HP-41CV PGILLET 12 3,569 11-03-2013, 02:46 PM
Last Post: Hans Holzach
  HP Prime: Rounding error in determinant Stephan Matthys 3 1,693 10-25-2013, 09:29 PM
Last Post: Walter B

Forum Jump: