Corrected command to build WP 34S assembler tables



#2

Hi All,

There is a typo in the Assembler documentation regarding building new opcode tables for SVN revision translations. Section 5.2, Figures 5.2 and 5.3, give incorrect command lines for doing this. The command line parameter "opcodes" is missing.

The correct command is (your path may vary):

$ calc opcodes > svn_XXXX.op

I will issue an updated manual in the next little while.

Sorry for the inconvenience (and thanks for spotting this Cristian!).


Possibly Related Threads...
Thread Author Replies Views Last Post
  [WP-34S] Unfortunate key damage with update to V3 :( svisvanatha 5 594 12-10-2013, 11:37 PM
Last Post: Les Bell
  WP-34S (Emulator Program Load/Save) Barry Mead 1 332 12-09-2013, 05:29 PM
Last Post: Marcus von Cube, Germany
  [HP-Prime CAS] "Warning, ^ (Command) Is ambiguous on non square matrices"?? CompSystems 1 401 12-07-2013, 07:15 PM
Last Post: CompSystems
  DIY HP 30b WP 34s serial flash/programming cable Richard Wahl 2 484 12-04-2013, 11:14 AM
Last Post: Barry Mead
  HP Prime - most favorite command bluesun08 2 379 11-12-2013, 11:29 AM
Last Post: bluesun08
  hp prime - command syntax bluesun08 6 537 11-10-2013, 11:57 AM
Last Post: bluesun08
  WP 34S/43 ?'s Richard Berler 3 443 11-10-2013, 02:27 AM
Last Post: Walter B
  My FrankenCulator (wp-34s) FORTIN Pascal 4 445 11-09-2013, 06:18 PM
Last Post: FORTIN Pascal
  WP 34S Owner's Handbook Walter B 5 616 11-09-2013, 05:34 PM
Last Post: Harald
  wp 34s overlay and programming. FORTIN Pascal 6 576 11-08-2013, 01:28 PM
Last Post: Nick_S

Forum Jump: