Board Stacking Connector HP-9815



#4

Anyone know a source for new PCA stacking connectors?

Original is a Teledyne Interconnect 40 pin connector with .100" spacing. The part number is B415U040.

Anyone fixed busted contacts on these before?


#5

I haven't seen them anyplace but in a 9815. Must have been one of these special, non-standard things that were typical HP fashion.

I did kludge one by splitting a standard PC-edge connector along its length, then gluing the two halves back-to-back with epoxy. After that, a little dose of point-to-point soldering to bridge the contacts did the trick. It didn't look good but it got the calculator to work!

Joel


#6

For what it's worth, I found out the Teledyne still makes these contacts and sells them for $13 each.

TELEDYNE IMPULSE
9855 Carroll Canyon Road
San Diego CA 92131-1103
Phone 858 842-3138
Fax. 858 565-1649

TKC Product Line. Catalog here


Possibly Related Threads...
Thread Author Replies Views Last Post
  [HP-Prime] connector made with printer3D CompSystems 0 136 10-18-2013, 04:53 PM
Last Post: CompSystems
  9815 data cartridge drive (also 9825 / 9845 / 85 / 87, and who knows what else) John Ioannidis 2 190 06-12-2013, 07:20 PM
Last Post: Craig Ruff
  9815 Service Module John Ioannidis 0 124 06-10-2013, 02:56 PM
Last Post: John Ioannidis
  Need manual for HP 44464a (a 3421a I/O board Alan Sciacca 1 121 03-12-2013, 03:31 AM
Last Post: Diego Diaz
  HP-65 logic board repair - help required Alberto Fenini 1 143 02-17-2013, 06:39 PM
Last Post: John Robinson
  Hp85 PRM-85 board Roe Peterson 2 177 12-08-2012, 12:00 PM
Last Post: Roe Peterson
  HP41 / SY41CL Mini-B USB Power Connector (Module) Matt Kernal 5 843 07-08-2012, 06:23 PM
Last Post: Diego Diaz
  [41CL] Alternative serial connector, saving a port Kerem Kapkin (Silicon Valley, CA) 24 822 07-06-2012, 11:51 AM
Last Post: aurelio
  hp 41 series wire-wrapped connector question. Matt Kernal 3 184 06-19-2012, 01:48 AM
Last Post: Luiz C. Vieira (Brazil)
  Can my CV take a CL board? Les Wright 5 281 06-03-2012, 08:33 PM
Last Post: Les Wright

Forum Jump: