HP 25 Battery Cover Stuck?



#2

Hi, I just acquired an HP25 calculator. It's in mint physical condition but I can't seem to remove the rear battery cover. Either I'm doing something wrong or there is a corrosion issue. Any suggestions? Thanks.


#3

The door is really the top of the battery pack, which you remove by sliding it forward towards the bottom of the calculator and then pushing down to release the rear of the pack. The battery cells are spring loaded and the springs should compress to allow the pack to slide forward when you push on it.

Edited: 2 Apr 2011, 6:02 p.m.


#4

Hi, Thanks, I tried that, it just doesn't budge.


#5

Is it possible for you to contact the seller about this? Sometimes these battery packs are rebuilt by splitting the case and then gluing it back together, such that the pack is slightly thicker and becomes a very tight fit in the calculator. I have a few that are a bit tight and require a bit of force to open, however, I've always been able to open them without resorting to prying, which will cause some cosmetic damage.


#6

Pop out the top two rubber feet and remove the two Phillips screws underneath. Now, with the same Phillips you removed the screws with, push on either one of the two charger input pins and push the keyboard assembly out at the top. Now you can lift the electronics up and out leaving you with the battery and case back as one piece. Once that is complete, you can easily remove the battery.

Edited: 2 Apr 2011, 8:34 p.m.


#7

I've opened plenty of Woodstock cases with the battery pack removed, but never with one installed. Wouldn't the pressure of the battery terminals against the pcb contacts prevent you from separating the keyboard assembly from the case and battery pack?


#8

As usual, Randy is absolutely correct. Simple undo the screws and gently push the contacts so that they clear the case internally.

I have had a few 'stuck' battery packs on the woodstocks.

Geoff


#9

Thank you everyone for your help. I'll give it a try.


Possibly Related Threads...
Thread Author Replies Views Last Post
  Strange HP 25 Problem (Repair) Onur Ilkorur 5 636 12-06-2013, 05:13 PM
Last Post: Onur Ilkorur
  HP-41 module covers and side port cover Nate Martin 1 357 12-02-2013, 01:51 AM
Last Post: Giancarlo
  HP-25 Wayne Selway 1 289 11-22-2013, 12:58 PM
Last Post: Michael de Estrada
  HP67/97 M.E. Pac cover Ignacio Sánchez 2 378 11-22-2013, 04:04 AM
Last Post: Ignacio Sánchez Reig
  request M.E. pac for HP-67/97 wallet cover scan Ignacio Sánchez 0 280 11-06-2013, 09:36 AM
Last Post: Ignacio Sánchez Reig
  HP-67/97 Mechanical engineering PAC cover Ignacio Sánchez 0 260 10-30-2013, 04:35 AM
Last Post: Ignacio Sánchez Reig
  Interesting Base Conversions - Porting a 1975 HP 25 Program to the HP 35S Eddie W. Shore 1 330 10-13-2013, 07:49 PM
Last Post: BruceH
  HP-25/25C Potential Matt Agajanian 14 1,138 07-17-2013, 02:57 AM
Last Post: Matt Agajanian
  Stuck Omnibook 300 pop-out mouse. Ideas? Gene Wright 5 524 07-03-2013, 02:52 PM
Last Post: Bill (Smithville, NJ)
  HP 39gii Stuck Again! Eddie W. Shore 3 343 03-06-2013, 07:47 AM
Last Post: Eddie W. Shore

Forum Jump: