HP Forums / HP Museum Forums / Old HP Forum Archives v / HP 25 Battery Cover Stuck?

Linear Mode
HP 25 Battery Cover Stuck?


▼
Post: #5
04-02-2011, 05:35 PM
M. Pollock (Canada) Offline
Unregistered
Posts: 3
Threads: 1
Joined: Apr 2011

Hi, I just acquired an HP25 calculator. It's in mint physical condition but I can't seem to remove the rear battery cover. Either I'm doing something wrong or there is a corrosion issue. Any suggestions? Thanks.

Find
▼
Post: #6
04-02-2011, 06:01 PM
Michael de Estrada Offline
Unregistered
Posts: 1,665
Threads: 142
Joined: Jan 2009

The door is really the top of the battery pack, which you remove by sliding it forward towards the bottom of the calculator and then pushing down to release the rear of the pack. The battery cells are spring loaded and the springs should compress to allow the pack to slide forward when you push on it.

Edited: 2 Apr 2011, 6:02 p.m.

Find
▼
Post: #7
04-02-2011, 06:29 PM
M. Pollock (Canada) Offline
Unregistered
Posts: 3
Threads: 1
Joined: Apr 2011

Hi, Thanks, I tried that, it just doesn't budge.

Find
▼
Post: #8
04-02-2011, 07:28 PM
Michael de Estrada Offline
Unregistered
Posts: 1,665
Threads: 142
Joined: Jan 2009

Is it possible for you to contact the seller about this? Sometimes these battery packs are rebuilt by splitting the case and then gluing it back together, such that the pack is slightly thicker and becomes a very tight fit in the calculator. I have a few that are a bit tight and require a bit of force to open, however, I've always been able to open them without resorting to prying, which will cause some cosmetic damage.

Find
▼
Post: #9
04-02-2011, 08:33 PM
Randy Offline
Unregistered
Posts: 883
Threads: 17
Joined: Feb 2006

Pop out the top two rubber feet and remove the two Phillips screws underneath. Now, with the same Phillips you removed the screws with, push on either one of the two charger input pins and push the keyboard assembly out at the top. Now you can lift the electronics up and out leaving you with the battery and case back as one piece. Once that is complete, you can easily remove the battery.

Edited: 2 Apr 2011, 8:34 p.m.

Find
▼
Post: #10
04-02-2011, 09:57 PM
Michael de Estrada Offline
Unregistered
Posts: 1,665
Threads: 142
Joined: Jan 2009

I've opened plenty of Woodstock cases with the battery pack removed, but never with one installed. Wouldn't the pressure of the battery terminals against the pcb contacts prevent you from separating the keyboard assembly from the case and battery pack?

Find
▼
Post: #11
04-03-2011, 03:19 AM
Geoff Quickfall Offline
Unregistered
Posts: 1,083
Threads: 126
Joined: Sep 2006

As usual, Randy is absolutely correct. Simple undo the screws and gently push the contacts so that they clear the case internally.

I have had a few 'stuck' battery packs on the woodstocks.

Geoff

Find
▼
Post: #12
04-03-2011, 08:40 AM
M. Pollock (Canada) Offline
Unregistered
Posts: 3
Threads: 1
Joined: Apr 2011

Thank you everyone for your help. I'll give it a try.

Find

Forum Jump: