Faceplate separation repair



#2

For a long time now my 32SII metal faceplate has been separating away from the plastic body ... right up near the top by the display.

Is there a particular glue (I assume) and method I should use to correct this? Also, I should "try" get something back in there and pull away the lint and stuff from behind it first. How might I do that? Seems a cotton swab would be too large.

Sorry if this has been covered before but I didn't have any luck with my search terms for a similar post and solution.


#3

check out HPSolve, June 2010:

June 2010

The second half of the restoration article explains the faceplate removal and glueing procedure.

I suggest you remove the faceplate, depending on how much has separated, as that way you can put a reverse curve on it so that it glues back to the case with the corners down. If the raised edges are not to great then a fine paint brush and contact cement will work. Make sure to press the glue joint for a few minutes to ensure it does not raise.

Cheers, Geoff


#4

Thank you for your input on this Geoff. I'm downloading the newsletter now and will look at it.

...

Perhaps I should just try using a fine paint brush to clean out the dust, then contact cement applied with the toothpicks first to see if I can get it to stay down. It's not raised any further back than to the bottom of the LCD display.

Edited: 30 Oct 2010, 10:25 p.m.

#5

Hi Geoff,

let me take the opportunity and ask about your book: When will it be available? What will it cost? Or is it on the market already?

TIA for your response,

Walter


Possibly Related Threads...
Thread Author Replies Views Last Post
  I think I know what the faceplate "issue" is Miguel Toro 2 178 08-08-2007, 09:12 PM
Last Post: sjthomas
  Pioneer calcs: Gaps between keys and faceplate cutouts Neil 3 172 08-22-2003, 05:18 PM
Last Post: Paul Brogger
  KBD faceplate protection: bringing back an old issue. Vieira, Luiz C. (Brazil) 7 321 07-01-2003, 06:36 PM
Last Post: David Smith
  HP-15C faceplate repair David Erdman 12 437 01-25-2003, 09:59 AM
Last Post: Vieira, Luiz C. (Brazil)
  HP-15C faceplate logo / emblem? Bryan 1 156 01-18-2003, 01:17 PM
Last Post: ToddG
  Removing 11C Faceplate steve 8 310 11-25-2002, 02:29 PM
Last Post: Raymond Hellstern (Germany)
  Faceplate on 42S Per Faltman(Sweden) 3 169 03-23-2001, 03:51 PM
Last Post: Paul Brogger
  HP 32SII faceplate change Richard George 2 143 10-27-2000, 04:38 PM
Last Post: Jim L

Forum Jump: