Classic display segment intermittent - cause?



#2

Hi - I recently added a nice HP-70 to my collection. It's in good shape overall, working.

When first powered up the "c" segment in each digit is off (identifying segments from "a" at top, clockwise). I've seen posts about this kind of fault (usually display driver?).

However, after about 5-10 minutes from cold power-on, the segment will behave correctly, for about 10 minutes, then the segment will extinguish again, and stay off (until the calc is switched off and left for a few hours).

So it seems to be some sort of "warm up" behavior. I'm going to go in with a scope etc and see what's going on, but from the collective experience of the forum, what might be wrong, or where should I start looking?

Cheers


#3

A bad anode driver is a likely culprit. Part number is 1820-1024 which is unique to the 70. While other classics use different part numbers in that position, they might function as they all share the same pin outs.


#4

Probably wishful thinking on my behalf, but I was wondering if this could be a bad solder joint or similar on the inductor?


#5

Well I finally opened up my HP-70 and did a full restore. Sure enough, the intermittent segment behavior (above) was just a very obvious dry solder joint - fixed in 10 seconds! Now I have a very clean, 100% functional HP-70!! Used Novus plastic cleaners for the first time, and very impressed.


Possibly Related Threads…
Thread Author Replies Views Last Post
  A Wonderful Classic HP Calculator BShoring 2 1,443 11-22-2013, 05:25 PM
Last Post: BShoring
  Classic battery polarity Kiyoshi Akima 2 1,638 11-08-2013, 01:31 AM
Last Post: Kiyoshi Akima
  CLASSIC/SPICE KEY LEGENDS Mike T. 2 1,447 08-21-2013, 04:53 PM
Last Post: Mike T.
  Woodstock, Classic & Spices for iPhone Matt Agajanian 8 2,954 07-10-2013, 06:10 PM
Last Post: BShoring
  Classic calculator display chip type number? Juergen Hofstaedter 3 1,639 01-22-2013, 12:47 PM
Last Post: Eric Smith
  New Blog Post: Length of a Polynomial Segment Eddie W. Shore 1 1,232 01-17-2013, 08:56 PM
Last Post: Namir
  Classic Series Enter Key Dan Lewis 15 4,534 12-19-2012, 09:10 AM
Last Post: Thomas Radtke
  Can the display for a HP32Sii be replaced with the display from another model? Bruce Larrabee 8 2,973 10-10-2012, 10:05 PM
Last Post: Luiz C. Vieira (Brazil)
  Classic (HP-67) charger issues revisited Matt Agajanian 6 2,445 05-20-2012, 10:50 PM
Last Post: Matt Agajanian
  Classic battery contacts james summers 2 1,594 04-08-2012, 01:45 PM
Last Post: james summers

Forum Jump: