Opening a Woodstock external charger?



#11

Does anyone have experience opening the woodstock series external charger (sometimes called a "reserve power pack")?

The thing is built into an attractive mini-woodstock case. But there are no screws on it (I checked under the rubber feet). I'd hate to pry it apart by force and crack the plastic.

-John


#12

I have a classic series charger (03502A) that is sealed with no screws. I'd like to open it so that I may repair the strain relief and check the electronics. The constant-voltage supply reads 6.7 V no load; this seems a bit high, although my 35 chargers and functions fine off of the supply.

-Tim


#13

The sealed, smaller chargers were ultrasonically welded as well. The circuity is totally different than the 82001 and the higher voltage is normal. Trying to open one will usually result in breakage... since the weld lines are not exposed.


#14

I didn't realize that the circuitry was different. Am I correct in assuming that these sealed chargers were supplanted by the more common four-screw classic chargers?

It's also good to know that the higher voltage is correct. I'll see to repairing the strain relief from the outside.

#15

how do you check output voltage?


#16

With the charger plug facing you, I measured between the center (common) and rightmost contacts. For a good picture, scroll about halfway down this page: http://www.jacques-laporte.org/HP35%20power%20unit.htm.

As for my HP-35 charger, some of the sealed plastic case is chipped away at the charger's strain relief. I used epoxy to fill in the missing parts. I also sliced a plastic strain relief off of an old in-line phono plug, cut it open, wrapped it around the charger cable where it emerges from the case, and secured it in place with more epoxy. This should reinforce the rather wimpy OEM strain relief.

Edited: 2 Nov 2009, 7:57 p.m.


#17

Thank you Tim

Charlie

#18

Like most HP calculator assemblies, it was ultrasonically welded. You're right, it will most likely crack if you attempt to part the pieces.

Nothing inside but a diode, resistor and LED. *Very* hi-tech ;^)

#19

Just to clarify...

I'm NOT talking about the AC adapter that plugs into the wall.

This is basically a box to hold the batteries. You then plug the AC adapter into this box instead of the calculator. It looks like a 2/3 size woodstock case complete with rubber feet, "hewlett packard" metal strip, and an LED to indicate charging. It serves the same function as the more common classic series little black hinge-top "reserve power packs".

Not sure I made that clear enough in my original post.

I've been using alkalines for years in my woodstocks. Now I feel the urge to switch to rechargables. I'm well aware of the hazards of in-machine battery charging, so I thought this little jewel would do the trick. It certainly looks better than anything I could construct. Only problem is I think the diode is blown. When I connect my AC sdapter to it, the battery charging contacts show a little over 10 volts AC! I've never actually tried to use it until now. It's just been sitting in my "accessories box" with all the spare AC adapters, armored security cradles, field cases, etc. that I never really use.


-John (3665)


#20

I happen to have a few of these and one was badly corroded and in need of repair. It had also been previously opened as there was a chip in the front. The two pieces of the shell are held together by what appears by glue around the boarder of the center rectangle. Here's a picture:

I think that it might be possible to break the glue bond without damaging the case, but it's not going to be easy.

The circuit is just a diode in series with what seems to be an 11 ohm 2 Watt resistor for charging and an LED in series with a 22 ohm resistor to indicate that current is flowing into the battery.

-Katie

Edited: 3 Nov 2009, 2:00 a.m.


Possibly Related Threads…
Thread Author Replies Views Last Post
  Usefulness of Woodstock Cs without their C Matt Agajanian 5 2,816 12-10-2013, 02:05 PM
Last Post: Geoff Quickfall
  HP-67 charger Marcel Samek 3 1,818 11-22-2013, 10:45 PM
Last Post: Marcel Samek
  HP Prime: Number of external Variables Davi Ribeiro de Oliveira 0 1,059 11-01-2013, 08:10 PM
Last Post: Davi Ribeiro de Oliveira
  opening hp 15c for repair FORTIN Pascal 4 2,081 10-12-2013, 10:35 AM
Last Post: FORTIN Pascal
  Woodstock, Classic & Spices for iPhone Matt Agajanian 8 2,953 07-10-2013, 06:10 PM
Last Post: BShoring
  HP-41cx External battery Jeff Davis 4 1,859 11-16-2012, 08:38 PM
Last Post: Luiz C. Vieira (Brazil)
  A Woodstock 67 Matt Agajanian 4 2,129 05-20-2012, 10:57 PM
Last Post: Mike Morrow
  Disassemble Battery Pack 82028B (woodstock) Jacques Karensky 0 1,168 05-19-2012, 03:39 AM
Last Post: Jacques Karensky
  Woodstock/Spice Keyboard Cleaning Revisited Matt Agajanian 0 1,076 05-12-2012, 03:43 PM
Last Post: Matt Agajanian
  HP-67 wall charger Wytnucls 2 1,407 04-19-2012, 10:13 PM
Last Post: Dan W

Forum Jump: