I have some very stubborn particles on the inside of the display lens of my 11C. Usually I use compressed air or a thin piece of laminated paper to clean it, but this material has some stick to it. I think my 2 options are to either remove the PCB by breaking the melted rivets, or, by removing the brushed aluminum faceplate which contains the plastic lens. I don’t think anyone has a good solution to reattaching the PCB, so I figured I try getting in through the faceplate. I'm assuming there's glue holding it in place. Is it possible to remove it without destroying the faceplate? Is there a better way? Thanks,
Steve