I have some CMT EPROMS that I would like to program, but have no fixture or programmer.
I do have a ZEPROM programmer, and programmed a couple of modules several years ago. Either as a trade or independently, I should be able to program ZEPROM modules again.
Does anyone (or know of anyone) who has a CMT EPROM programming fixture?
Related question: The modules that I have are 16K CMT-10 modules, and are currently programmed to fill the address space of two adjacent ports. From the little documentation that I have, it appears that these cannot be used in a bank-switched mode (probably missing the hardware?). Does anyone know if it is possible to turn off one half of the module so that it only uses the address space of the port that it is plugged into, 8K?