Hi all,
I just wanted to share my DIY way to a very usable overlay:
I printed the overlay png that comes with the WP34s package on a color laser printer at a width of 68mm. I cut it out and laminated it, then folded it in the appropriate places and just scotch taped it together on its rear. The laminated overlay is flexible enough to get accurate key response. The overlay is easily applicable and removed again. The only problem is the [ON] key which is a bit flatter than the rest and needs some special care to press.
The work took me about 15 minutes, 10 minutes taken by the heating of the laminating machine. ;-)
Edited: 25 Aug 2011, 12:21 p.m.