DeSoldering SMD Components easily!!! - Chipquik



#3

I have not yet tried this stuff, but the videos show it makes removing even 4-sided SMD components very easy!!!

It's a low temperature - high heat retentivity solder that stays liquified while you can heat up all four sides of smd component to then slide it off!!!

http://www.chipquikinc.com/index.htm

R,
TomC


#4

I think that stuff would be a "must have" if you need to save the components you remove. So far, I've only been upgrading the 42s so it is cheaper for me to just bend up one pin at a time to remove it. I'm just tossing the 8K chip I take out anyway.

Dave


Possibly Related Threads...
Thread Author Replies Views Last Post
  OT: I can't Believe I found this so easily: HBO Intro bill platt 2 1,100 05-31-2012, 12:23 PM
Last Post: bill platt
  Need help identifying a few components. Bruce Larrabee 2 905 01-31-2012, 07:39 PM
Last Post: Paul Berger (Canada)
  Classic Series Logic Board - Desoldering Temp ? John Robinson 7 1,539 09-17-2009, 09:36 PM
Last Post: Dan W
  HP components Luis 3 965 10-29-2003, 02:03 PM
Last Post: Luis
  HP Printer Components Speck 2 741 04-18-2003, 12:58 AM
Last Post: Ellis Easley
  Identifying 82120a components Vieira, Luiz C. (Brazil) 0 507 01-22-2003, 12:23 PM
Last Post: Vieira, Luiz C. (Brazil)

Forum Jump: