HP41CV On rocker switch
#1

I want to bring my HP41CV back into use. With new batteries in it will not operate. No visual problems with on rocker switch. I s this a common fault. Any useful advice gratefully received

#2

Most of the time, problems with the HP41 series are due to bad internal contacts.

The battery pack and modules connect to a flexible PCB that's held against the keyboard PCB by a strip of foam and the screws that hold the case together. The 'Fullnut' machines have a separate logic PCB that's connected to the keyboard by a zebra-strip type of connector, again clamped by the case screws.

If you are happy working on static-sensitive electronics, you could open it up (take out the battery pack, peel off the feet, the screws are under them) then clean the contacts with propan-2-ol (isopropanol, isopropyl alcohol). When reassembling, do not overtighten the screws, if you strip the thread in the top case, you will have a lot of work to do.

#3

My experience is HP-41s usually only needs to be reset. For some reason, starting one up after a long "vacation" does not do this simply by putting in new batteries. I've even had a "returnee" go on strike when I connected the card reader for the first time. Seems once they know you will be using them a while, they do quite well - I guess we hurt their feelings by ignoring them for so long. Seems HP had AI 25-yrs ago and didn't really know it!

Refer to your Owners Manual; My CV Manual on pg 242 says:
"...#3 While holding down the <- key (the correction key) turn the calculator ON. This is a "master clear" and the entire calculator will be cleared."

This is also described near the bottom of pg 23 in the paragraph ending with the blue MEMORY LOST.

Hopefully this will do it for you and you won't have to give your CV a frontal lobotomy - just a swift kick!

Bob



Possibly Related Threads...
Thread Author Replies Views Last Post
  hp41cv memory modules tim peterson 10 1,257 11-07-2013, 11:09 PM
Last Post: Garth Wilson
  HP41CV Mike Powell 12 1,263 10-30-2013, 08:17 AM
Last Post: Mike Powell
  HP41CV Bry Sun 11 1,284 10-22-2013, 12:52 PM
Last Post: Geoff Quickfall
  HP41cv expiriences of a new user Wolfgang 28 2,254 02-13-2013, 08:02 PM
Last Post: Mike Morrow
  A simple question about the HP41C or HP41CV Antoine M. Couëtte 6 790 12-16-2012, 04:06 AM
Last Post: Antoine M. Couëtte
  Request for HP 30b program to switch to ALG-RPN Sujith Abraham 1 336 09-27-2012, 11:00 AM
Last Post: Bruce Bergman
  Problem with HP41CV Bruce Larrabee 19 1,738 09-18-2012, 09:29 AM
Last Post: Luiz C. Vieira (Brazil)
  HP41CV drains battery. Schematics? Harald 15 1,478 03-18-2012, 09:22 PM
Last Post: Luiz C. Vieira (Brazil)
  HP41CV batteries John Abbott (S. Africa) 3 542 03-02-2012, 06:15 AM
Last Post: John Abbott (S. Africa)
  HP41CV faulty Steve Hunt 6 696 12-27-2011, 12:45 AM
Last Post: Kerem Kapkin (Silicon Valley, CA)

Forum Jump: