HP-34C Pr Error
#1

My HP-34C is always running Pr Error when I put the switch on (except when I trun It very quickly). I try hundred of pages on the web without succes. Connector are clean, but the ribbon (the one which is connected to connector of the battery pack) seems not properly rebuild (!). Does anybody know how to keep permanent memory (ie no Pr Error when the calculator is ON) ? Perhaps a photo of the connection could help me in case of a non properly rebuilt ribbon. Or also the disposition of the three ships not soldered.
Sorry for my poor English (I'm living in France) Thank you

#2

It's probably a bad battery pack that doesn't hold charge.

I bought my 34C with this problem, but after rebuilding the pack, it's like new.

Directions for rebuilding battery packs are found elsewhere at this site.

Good Luck!

#3

Hi:

Probably it has been manipulated and there is a chip in wrong position. If you can dissasemble it and post the chips´identification probably I can help you.

Jon

#4

I'll do that, just a few hours
Regards



Possibly Related Threads…
Thread Author Replies Views Last Post
  [HP Prime] "Error while checking exact value with approximate value, returning both!" Chris Pem10 13 4,944 12-06-2013, 05:12 AM
Last Post: parisse
  MS advert shows spreadsheet with obvious error BruceH 3 2,146 11-14-2013, 09:50 AM
Last Post: Bill (Smithville, NJ)
  HP Prime: Rounding error in determinant Stephan Matthys 3 1,607 10-25-2013, 09:29 PM
Last Post: Walter B
  HP Prime Error: Summation Upper Bound > 1000 HP Pioneer 2 1,351 10-25-2013, 11:32 AM
Last Post: steindid
  Prime Error or Mine? toml_12953 12 3,531 10-22-2013, 10:35 AM
Last Post: toml_12953
  Explaination on How to Reset Caculator in Users guie: error Harold A Climer 5 2,512 10-15-2013, 02:11 AM
Last Post: cyrille de Brébisson
  Repair of HP-34C - Error 0 and Error 9 Jeff Kearns 3 1,643 10-11-2013, 12:29 PM
Last Post: Randy
  HP-34C Draining battery quickly Bill Crowell 2 1,338 09-08-2013, 08:30 AM
Last Post: aj04062
  Do You Think a Listing Error Was Made? Jim Johnson 13 3,775 09-04-2013, 09:23 AM
Last Post: Eddie W. Shore
  HP-34C Curiosity Matt Agajanian 7 2,609 08-23-2013, 06:02 PM
Last Post: Stephan Matthys

Forum Jump: