Simply enough I have lost the battery cover for the unit and am looking for a new one--any ideas?
hp12c
|
04-15-2004, 04:41 PM
04-15-2004, 05:49 PM
Look in the archives--I think two back. Luiz Vieira made a new door for a pioneer from scratch! Perhaps you can apply the same principles to a "voyager" (10c 11c 12c 15c 16c)
Bill
04-15-2004, 08:52 PM
The links to the images no longer work. Did anyone save copies? Luiz?
04-16-2004, 04:53 PM
Hi, all; thank you guys; being remembered this way is an honor! 8^) Here is an image of the final "work":
These are references to other images:
http://www.logeng.com.br/images/pion_door_1.jpg As you can notice, I used a protective (movable) cover from an old VHS tape. It's easy to be seen by the known advice (Do not touch the tape inside). I "carved" it till it fit in place, then I added the small parts that serve as "guides" for holding in place. I used a small clamp to make sure the parts were hold together while the glue was drying out. About the glue: I used super glue, but there are better choices. The irregular surface was obtained with thin sandpapper with a (latter applied)solvent (thinner). I don't have the main text from the original post, but I may add more information if needed. Hope this helps for now. Cheers.
Luiz (Brazil) Edited: 16 Apr 2004, 4:55 p.m. |
« Next Oldest | Next Newest »
|