HP 20S with very high "off" current
#1

I have a 20S of unknown heritage (S/N 3251SXXXXXX) that burned through a brand new set of 357 batteries in less than one week.

The display of the 20S is very dark -- call it a large dark smudge across its middle. When running, the information is visible and not that compromised.

I measured the current of both the 20S and a functional 10B with the following results:

State            20S      10B
off 1.14mA <1uA
on (idle) 1.29mA ~100uA
button pressed 2.7mA 2.03mA
running (!n) 3.2mA 1.94mA

I haven't ripped the 20S apart (yet) but I believe its internals are virtually identical to a 10B. I have previously ripped my 10B apart and my recollection is that it has nothing more than the single IC and the power supply capacitor.

Any ideas of what the issue might be? Could the cap be bad? Is the (dark) display at fault? (It would be worth swapping the keyboard/display assembly between the 2 units to see if it is the display.)

Its not particularly valuable but I wouldn't mind trying to get it working again.

Cheers...

#2

I think it's most likely to have a really leaky (i.e., high leakage current) chip. I've got a 32sii, latest color scheme, calculator with the same problem. If so, there's nothing you can do to fix it. However you can try to change the capacitor -- or just remove it to see if that helps the current draw problem. The dark LCD issue might be related only in the sense that the calculator has apparently seen some difficult environmental conditions.

#3

Thanks Katie.

Even though I could not see any cold solder joints on the processor with my hand loupe, several appeared a bit oxidized. I scrubbed with vinegar and then reflowed all the joints. Bingo, the current returned to normal and the calculator is working as expected again (albeit with the dark display).

Maybe you want to give that a go on your 'leaky' 32sii.

Best of luck!



Possibly Related Threads…
Thread Author Replies Views Last Post
  HP 20S Kate Field (Corvallis) 1 991 07-03-2013, 07:41 PM
Last Post: Peter Murphy (Livermore)
  HP-35 and HP-65 Current Requirements Dan Lewis 0 917 03-05-2013, 12:11 AM
Last Post: Dan Lewis
  New high def picture of new TI-84 Plus Color SE Mic 17 4,710 11-26-2012, 04:17 PM
Last Post: Luiz C. Vieira (Brazil)
  Charging Current in HP97, 82143A, 82162A Les Wright 5 2,017 06-17-2012, 02:11 PM
Last Post: Les Wright
  HIGH END HPs.. Status Symbols?? John W Kercheval 13 3,473 05-09-2012, 12:55 AM
Last Post: Matt Agajanian
  HP-15C LE : Workaround for the high current spike Lyuka 14 3,828 01-12-2012, 04:43 AM
Last Post: Lyuka
  HP50g - High power consumption Frido Bohn 2 1,155 10-21-2011, 04:34 AM
Last Post: Frido Bohn
  wanted: high-resolution photo of 50g internals Eric Smith 9 2,915 10-04-2011, 02:08 AM
Last Post: Marcus von Cube, Germany
  Current Consumption and Program Performance HP15CLE Thomas Chrapkiewicz 4 1,534 09-21-2011, 09:41 PM
Last Post: DaveJ
  15C LE current draw issue Katie Wasserman 36 7,656 09-15-2011, 09:53 AM
Last Post: bill platt

Forum Jump: