HP-IL SCSI Interface
#1

I recently came across two of these (Part number = 5061-3156) and can find no information about them.
They did not come with their 'Wall Warts" so I'm reluctant to experiment with them.

The Museum and TOS are also void of any data.

Any information pointers would be appreciated.

Thanks,

Rick

#2

Are they HP-IL, or HP-HIL?

Photos?

#3

The labeling says HP-IL/SCSI Interface.

There are three connections: One for power. one set of HP-IL plugs
and one 50 pin SCSI connector.

Photos soon.

Rick

#4

I'm wondering which kind of devices can be connected to a 71B or 41C. The SCSI devices (mass storage, scanners) need special drivers and are far from being supported by the built in software of these two calculators. Or does the interface provide the access logic to use an SCSI disk as an HP-IL mass storage device?

#5

The latter is the only explanation that makes sense to me.

Now all you need is a SCSI-1 disk and cable :)

OK, we have TCP/IP, and now SCSI. Can an HP-IL NAS be far behind?

#6

I'm only guessing, but I think most likely it would be for the 110, not the 41/71/75. It probably translates SS/80 commands to SCSI.

The 41/71/75 don't use the SS/80 command set, they only use the "Filbert" command set from the 82161A tape drive. (It is rumored that the 82479A Data Acquisition Pac for the 71B can talk to SS/80 disks, but probably only in a limited, application-specific manner.)

The 9114 supports both the Filbert and SS/80 command sets, so it can be used on the 41/71/75 and on the 110.

#7

Check out the three pictures I loaded to my Picasa account.
[EDIT] try this link.
Rick

https://picasaweb.google.com/103635590211074260885/February172012?authkey=Gv1sRgCLHK2_T_5dmpQg

Edited: 17 Feb 2012, 5:16 p.m. after one or more responses were posted

#8

Picasa reports "Sorry, that page was not found."

#9

I edited the link - please try again.

Rick

#10

Interesting they look like prototypes. The connector to the right of the HPIL connectors is likely the power connector and the type might suggest it is looking for DC voltage, but you would need to look inside to see how it is wired. You will probably find that connector goes to a 3 terminal 5 volt regulator inside.

#11

If you can power it on, it would be interesting to know the answer to the HP-IL Identification requests (AID, ID on HP-41C; DEVAID(), DEVID$() on the HP-71B).

#12

I'm going to pull the cover off and take more photos, but this adventure will have to wait until next week.

#13

OK this is from a long long time ago, but I think these were field diagnostic exercisers for SCSI disks. I am not sure what HP-IL controller they were supposed to connect to, but the gist is that they were used to run diagnostics on SCSI disk drives.

I'll check my notes when I get home and see if I can dig some more info.

**vp

#14

Didn't need to check my notes after all, Google is my friend :-)

http://bitsavers.org/pdf/hp/disc/5960-0163_Using_Mass_Storage_Diagnostics_with_the_HP-IL_Interface_Jun90.pdf

**vp

#15

The software described in this manual is pretty similar to software that I used for failure analysis on SCSI disks. The software I used could be used to dump internal logs from the drive, update firmware and also worked as an exerciser. It was one of my tools along with a bus analyzer for trouble shooting shooting SCSI device issues.

#16

Well now at least I know what kind of P/S it needs!

Thanks for finding this document


Rick



Possibly Related Threads…
Thread Author Replies Views Last Post
  How to move lexfiles from PC to 71 w/o HP-IL? Joe Horn 9 3,202 10-18-2013, 03:50 PM
Last Post: Christoph Giesselink
  HP48GX Interface to a PC John W Kercheval 7 2,658 09-29-2013, 10:53 AM
Last Post: John W Kercheval
  HP Prime "Symb" interface (bug?) Han 8 2,388 09-13-2013, 12:48 PM
Last Post: Chris Tvergard
  Hand Held Products RS232 to HP-IL aj04062 11 3,367 08-31-2013, 07:12 PM
Last Post: Paul Berger (Canada)
  HP IL over wifi ... (ILPer & go71b) Olivier De Smet 12 4,005 08-20-2013, 05:44 AM
Last Post: Olivier De Smet
  Virtual HP-IL Video Interface ILVideo the 2nd! Christoph Giesselink 3 1,541 08-15-2013, 06:49 PM
Last Post: Sylvain Cote
  HP 85 Serial Interface; INPUT Example? inaki 1 1,225 06-12-2013, 11:09 PM
Last Post: Paul Berger (Canada)
  Trouble with RS-232/HP-IL Interface (HP 82164A) Hans Holzach 9 3,118 01-08-2013, 01:52 AM
Last Post: Marcus von Cube, Germany
  Virtual HP-IL 40 col. video interface simulation Christoph Giesselink 10 3,168 08-19-2012, 06:46 PM
Last Post: Richard Wagoner
  Cursors on Video Interface HP82163 Christoph Giesselink 4 1,837 07-21-2012, 02:57 PM
Last Post: Sylvain Cote

Forum Jump: