Aristo M85 -- What charger?
#1

What charger does this model take? Assume I need it spelled out for a 1st grader. ;-)

Isn't it beautiful? I think so!

#2

Very pretty!

All you need to know about charging these old calculators is the shape and polarity of the plug and the number/size of the nicad cells. Almost all of them use AA, so figure that back then they were around 700mAH per cell and charge at a 1/10 rate. Voltage isn't important, just enough to give you current needed, 70mA in this case. Of course almost no vendor used a regulated charger back then so the 70mA should be the average during the charging cycle -- it will be more at the start and less at the end.

Back when I used to charge my rechargeable calculators, I would experimentally pick a charger from a box of junk ones and measure the current when connected to the numbers of cells in the calculator. When I found the right one I'd solder on a plug and that was my custom-built charger. This worked great until I tired of charging them every few months. That's when a moved to primary AAA cells in plastic battery holders to replace AA nicads. Additionally, I use Energizer lithium AAA cells since they have near zero self discharge and never seem to leak.

#3

There is a special ARISTO charger on the market - well, I should say it was, but you find it on a German auction site every once and a while. And yes, ARISTO got awards for "good industrial design" quite regularily those days. You know why :-)

#4

Gene,

I received last week an M85S from Germany including a 230V charger.

Two choices: You wait three weeks and bid on my auctions OR you wait a few hours and I measure the voltage on its tip.

I have a few 220V outlets in my home (sewing machine, calculators, fondue set, raclette etc).

Cheers,
Joerg

PS: Glad you like German design.

#5

M85: 3x AA (accu pack or normal batteries), external AC power supply 7.5V, minus on center

(Thimet.de)

#6

Ah, so I can get a universal adapter with 7.5V, minus on center, and output of around 70 mill-amps and it ought to work.

Or, try Katie's approach of yanking all these rechargables out for alkalines!

#7

Aristo M-85

Why do not use ordinary batteries 3 x 1.5 AA?
Specs:4.5v DC using 3 x AA size batteries.
It accepts an adaptor (type 6795) through a socket on the top side to the far left.
You have to take the whole back off to access the three (2 plus 1 separated) battery slots, one of which is not used.


Edited: 3 Nov 2011, 3:43 p.m.

#8

Actually, it has new rechargeables inside.

I just need to know what exact type of charger to use, which I think is the one Joerg specified!

#9

The old AC nicad chargers were usually not regulated, most new universal ones are. So a 7.5 volt setting will be 7.5 volts all the time, that's almost certainly going to pump way too much current into the 3 x AA nicads and they will get hot and be damaged.

The old AC chargers were essentially current limited devices due to their small transformer size, that's what kept the nicads from overheating and being damaged. The voltage rating on them was just a nominal value for "voltage at the rated load" if they had a rated load. If they had no rated load the voltage was pretty much meaningless, open circuit these would often be twice the stated value. There's no substitute for actually measuring the current draw when trying to fit a charger to a calculator.

The ideal solution is to get an external power supply that let's you limit the current and monitor it. Then you'll really know what's going on and have a single charger for all your calculators.
For not much money you can find ones that are perfect for almost any battery powered calculator:

here's an example

here's one with a big more range

I wouldn't use these for anything other than battery charging, but they should be great for that.

#10

The LED version of the Aristo M85 is designed to be operated with 3xAA Alkaline or NiCd cells or with a 7.5V= max.200mA voltage supply (Aristo #6790) to save batteries. I have just verified that minus is on center.

The M85 is NOT designed to recharge batteries inside the calculator, so please do NOT try to connect it to a current source. Aristo sold an external recharger (#6795) for NiCd cells. Actually, the M85 runs quite long on a single set of Alkalines, so you'd be best off just using these.

The "M85 S" model has a builtin NiCd battery. There was a later version of the M85 with a green fluorescent display operating on 2xAA cells.

This is one of the most beautiful and mechanically best calculators ever built. The keys have no click, but excellent response. They precisely register at approx. 1/3 of their 2mm travel without bouncing ever, even after 40 years of (initially intense, later occasional) use.

IIRC, its LEDs were manufactured by HP. Arithmetic is chain logic (i.e. no precedence, two levels of parentheses). Log, exponential and trigonometric functions are computed to six digits.

Kind regards and enjoy, Mike

Edited: 3 Nov 2011, 5:02 p.m.



Possibly Related Threads…
Thread Author Replies Views Last Post
  HP-67 charger Marcel Samek 3 1,707 11-22-2013, 10:45 PM
Last Post: Marcel Samek
  OT: functional picture of an ARISTO M27 Mike (Stgt) 2 1,350 06-20-2012, 03:20 AM
Last Post: Mike (Stgt)
  HP-67 wall charger Wytnucls 2 1,309 04-19-2012, 10:13 PM
Last Post: Dan W
  HP 97 charger Harald 2 1,244 03-30-2012, 02:01 PM
Last Post: Harald
  Which charger for a35 Matt Agajanian 3 1,486 03-23-2012, 02:58 AM
Last Post: Marcus von Cube, Germany
  OT: looking for pic of an ARISTO M27's backside Mike (Stgt) 7 2,213 01-26-2012, 11:48 AM
Last Post: Maximilian Hohmann
  HP97 charger Olivier De Smet 5 1,775 09-20-2011, 06:53 AM
Last Post: Paul Berger (Canada)
  HP-67 AC Charger Ángel Martin 6 2,123 06-25-2011, 07:31 PM
Last Post: Trent Moseley
  N Size Cell Charger Gerry Schultz 3 1,454 06-17-2011, 12:14 PM
Last Post: Gerry Schultz
  Repairing HP82066B charger Timo 7 2,343 01-08-2011, 04:22 PM
Last Post: Timo

Forum Jump: