HP Forums › HP Museum Forums › Old HP Forum Archives v
Corrected command to build WP 34S assembler tables

Thread Modes
Corrected command to build WP 34S assembler tables
Neil Hamilton (Ottawa) Offline
Senior Member
Posts: 255
Threads: 22
Joined: May 2011
#1
07-25-2011, 06:38 AM

Hi All,

There is a typo in the Assembler documentation regarding building new opcode tables for SVN revision translations. Section 5.2, Figures 5.2 and 5.3, give incorrect command lines for doing this. The command line parameter "opcodes" is missing.

The correct command is (your path may vary):

$ calc opcodes > svn_XXXX.op

I will issue an updated manual in the next little while.

Sorry for the inconvenience (and thanks for spotting this Cristian!).

Find


Possibly Related Threads...
Thread Author Replies Views Last Post
  [WP-34S] Unfortunate key damage with update to V3 :( svisvanatha 5 2,471 12-10-2013, 11:37 PM
Last Post: Les Bell
  WP-34S (Emulator Program Load/Save) Barry Mead 1 1,347 12-09-2013, 05:29 PM
Last Post: Marcus von Cube, Germany
  [HP-Prime CAS] "Warning, ^ (Command) Is ambiguous on non square matrices"?? CompSystems 1 1,657 12-07-2013, 07:15 PM
Last Post: CompSystems
  DIY HP 30b WP 34s serial flash/programming cable Richard Wahl 2 1,945 12-04-2013, 11:14 AM
Last Post: Barry Mead
  HP Prime - most favorite command bluesun08 2 1,224 11-12-2013, 11:29 AM
Last Post: bluesun08
  hp prime - command syntax bluesun08 6 1,928 11-10-2013, 11:57 AM
Last Post: bluesun08
  WP 34S/43 ?'s Richard Berler 3 1,611 11-10-2013, 02:27 AM
Last Post: Walter B
  My FrankenCulator (wp-34s) FORTIN Pascal 4 1,690 11-09-2013, 06:18 PM
Last Post: FORTIN Pascal
  WP 34S Owner's Handbook Walter B 5 2,132 11-09-2013, 05:34 PM
Last Post: Harald
  wp 34s overlay and programming. FORTIN Pascal 6 2,321 11-08-2013, 01:28 PM
Last Post: Nick_S

Forum Jump: