removing alluminium bezel (was restoring an HP11C)
#1

ciao a tutti,

I had finally the chance to take few pics and upload them







The keyboard bezel has already been restored to my best effort,with a very thin brush and opaque black enamel
(I always forget to take picture before...)
The logo will be restored using the same technique, since I have tried with some silver markers but these are way too opaque, so I'll go for some chrmoe enamel.
However, I have tried to brush with some sandpaper the aluminuim bezel, with little improvement, which is why I'd like to remove it and brush it much better.
Has anyone done it ?
As always, thank you very much for help, take care and have a nice day,
Alberto

#2

I have removed a bezel using dental floss slipped under the edge, and worked carefully across the length of the bezel. You have to be careful with the grounding springs, but if you know where they are, you can avoid damaging them.

#3

Thank you very much for your message

You mean the two springs that can be removed unscrewing the backplate, right ?
I could remove them first, and then using the dental floss remove the bezel...
I'll give it a try, and let everybody know
thanks for help, Alberto



Possibly Related Threads...
Thread Author Replies Views Last Post
  restoring HP29C - help needed Alberto Fenini 9 1,312 11-25-2012, 07:56 AM
Last Post: Alberto Fenini
  Glue for HP42S bezel Basil 0 385 08-08-2012, 12:23 PM
Last Post: Basil
  Removing WP 34S overlay Jim Horn 6 928 06-29-2012, 07:26 PM
Last Post: JimHorn
  Restoring an HP65 (trying to .... few pics) Alberto Fenini 31 3,929 06-29-2012, 10:55 AM
Last Post: Peter HOFMANN
  Restoring an HP-55, advice appreciated ! Alberto Fenini 4 842 05-15-2012, 03:43 AM
Last Post: Alberto Fenini
  Hp 12C replacement bezel James Nelis 0 413 04-06-2012, 06:37 AM
Last Post: James Nelis
  Restoring silver trim: solution found >> tim m. 2 592 10-07-2011, 12:19 AM
Last Post: tim m.
  Removing 9810 printer snap rings (circlips) David Ramsey 5 787 09-06-2011, 01:32 PM
Last Post: David Ramsey
  Fixing the bezel on a 10C Keith Midson 8 1,078 09-03-2011, 05:00 PM
Last Post: Dan W
  Bezel exchange hp 12C Diehl-Peshkur 2 537 05-16-2011, 11:37 AM
Last Post: Diehl-Peshkur

Forum Jump: