HP 25 Display error
#1

Hello out there,
my 25 shows -when switched on- only one or two zeros.
The position manipulate herself when I switch it on a second time.
Any with an idea ?

My 21 has a bad LED at position eight - I cleaned the contacts without an result. Couldt this be a chip failure?

Regards

#2

Around 85 percent of similar failures seem to be caused by a defective ACT chip (the 22 pin, 0.4 inch wide chip). Most likely the bad digit in the LED is a bad LED display module (80%) or a bad cathode driver chip (20%).

#3

Are such chips available today, aside from scavenging from another calculator?

#4

Nope, like 99% of all chips in HP calculators the only way to get them is to salvage another machine.

#5

Thank you for information.
I changed the LED - same result, the 8th digit dosn´t
light up on my 21.
best regards

#6

If you want an HP25 that works and are willing to gamble your HP21, then you can remove the HP21 ACT chip and use it in the HP25... something not recommended unless you (or somebody you know) are quite skilled at desoldering and soldering.



Possibly Related Threads...
Thread Author Replies Views Last Post
  Strange HP 25 Problem (Repair) Onur Ilkorur 5 1,284 12-06-2013, 05:13 PM
Last Post: Onur Ilkorur
  [HP Prime] "Error while checking exact value with approximate value, returning both!" Chris Pem10 13 2,347 12-06-2013, 05:12 AM
Last Post: parisse
  HP-25 Wayne Selway 1 586 11-22-2013, 12:58 PM
Last Post: Michael de Estrada
  MS advert shows spreadsheet with obvious error BruceH 3 1,032 11-14-2013, 09:50 AM
Last Post: Bill (Smithville, NJ)
  HP Prime: Rounding error in determinant Stephan Matthys 3 781 10-25-2013, 09:29 PM
Last Post: Walter B
  HP Prime Error: Summation Upper Bound > 1000 HP Pioneer 2 666 10-25-2013, 11:32 AM
Last Post: steindid
  Prime Error or Mine? toml_12953 12 1,758 10-22-2013, 10:35 AM
Last Post: toml_12953
  Explaination on How to Reset Caculator in Users guie: error Harold A Climer 5 1,137 10-15-2013, 02:11 AM
Last Post: cyrille de Brébisson
  Interesting Base Conversions - Porting a 1975 HP 25 Program to the HP 35S Eddie W. Shore 1 643 10-13-2013, 07:49 PM
Last Post: BruceH
  Repair of HP-34C - Error 0 and Error 9 Jeff Kearns 3 807 10-11-2013, 12:29 PM
Last Post: Randy

Forum Jump: