HP 35s question
#1

Is it possible to recall from the stack (RCL stack T, Z, Y)?

Thanks for your help.

Bill :-)

#2

While programming (ALG, RPN), just use the "R down" key and you'll be presented with a choice for X, Y, Z and T. Use left and right arrows and ENTER to choose. In RPN calculator mode you only have "R down". In ALG you'll see the X,Y,Z and T choice after pressing "R down".


Edited: 22 Oct 2007, 5:09 a.m.

#3

If I remember correctly (my 35s isn't in front of me at the moment), in RPN mode, press any key that brings up a menu (e.g. Flags) and then press RollDown, and you'll get a menu of stack registers. Pressing one recalls that register (or inserts a REG_ instruction if you're in PRGM mode).

Stefan

#4

In RPN, if you are in PRGM mode this method allows to review the stack content and insert a REG_ instruction without needing to press the EQN key. In RUN mode, it only allows to review the content of the stack, not to recall the values, unfortunately.

Look at this link for more details.

Regards,

Miguel

#5

Thanks to all, that did it.

Bill :-)



Possibly Related Threads...
Thread Author Replies Views Last Post
  HP-35s current production line question Jaime Morales 9 1,631 11-18-2010, 05:24 PM
Last Post: uhmgawa
  Question about SOLVE on hp 35s Matt 7 1,488 08-05-2007, 06:14 AM
Last Post: Matt
  Upcoming 35s question #2 Gene Wright 5 1,213 07-12-2007, 05:24 PM
Last Post: Thomas Radtke
  Upcoming 35s question #1 Gene Wright 5 1,164 07-11-2007, 10:14 PM
Last Post: ECL

Forum Jump: