I was looking at the programs we have here, and in the longer quadratic program, it lists a command that I am not familiar with.
026 RCL: 1
I understand the RCL and the 1, but what does the colon signify and how do I enter that on the 15C?
- John
15C program question
|
06-06-2007, 09:26 AM
I was looking at the programs we have here, and in the longer quadratic program, it lists a command that I am not familiar with. 026 RCL: 1 I understand the RCL and the 1, but what does the colon signify and how do I enter that on the 15C? - John
06-06-2007, 09:32 AM
It probably is a "division" operation, so just press the RCL key, the division key, and the "1" key. Best regards from V.
06-06-2007, 09:35 AM
Thanks... that's odd... normally you will see / for division. Thanks again for the heads up.
06-06-2007, 10:51 AM
is it RCL <decimal point> 1 i.e. RCL 11 ?
06-06-2007, 01:31 PM
No... it is a colon.
06-06-2007, 02:52 PM
If you are referring to http://www.hpmuseum.org/software/15cquad.htm then it should be RCL/, not RCL:.
Register 1 contains 2a, so RCL/ 1 is required to get the correct answer.
06-06-2007, 03:38 PM
Well, I treated the colon as a divide, so it really wouldn't matter. Is there something else the colon can stand for as I have seen it before, but then a few lines below I would see them use the forward slash so it was as if they were using it interchangeably, which does not make any sense.
06-06-2007, 10:01 PM
Quote: As Valentin and others have stated, I think it's supposed to be "divide". The original intent was probably to superimpose ":" on "-", to make a divide sign. A capital theta can similarly be formed by superimposing "-" on a "0". -- KS |
« Next Oldest | Next Newest »
|