HP Forums
ThinkJet Priner Problems - Printable Version

+- HP Forums (https://archived.hpcalc.org/museumforum)
+-- Forum: HP Museum Forums (https://archived.hpcalc.org/museumforum/forum-1.html)
+--- Forum: Old HP Forum Archives (https://archived.hpcalc.org/museumforum/forum-2.html)
+--- Thread: ThinkJet Priner Problems (/thread-92725.html)



ThinkJet Priner Problems - Mike - 05-16-2006

I have a bunch of 2225B printers. I finally got around to testing some of these. Some of them work fine and other just don't print at all. I have used good, working ink cartridges for testing. I have also used a battery pack that holds a charge.

Is there some common problem with these that won't print? I tried cleaning the print head interface but it didn't help. Just seem odd that they won't print at all. Just curious if there is some common problem.




Re: ThinkJet Priner Problems - Tony Duell - 05-17-2006

If by "don't print" you mean that the thing goes through the motions -- the head and paper move -- but no ink comes out, even with a known-good cartridge, then yes there is a very common cause for this.

The flexible PCB that connects the cartridge to the logic board gets corroded at the cartridge end by ink leaking from the cartridge. Therefore no signals get to the cartridge any more.

The way to test this is to take the printer apart, unplug the flexible PCB from the logic board, and, with a good cartridge in place, to measure the resistance between the common trace (this is wider than all the others, I think it's in the middle) and each of the others. It should be quite a low resistance (10's of ohms?). If you get essentiallly infinite resistance, the flexible PCB is defective.

I have not found any way to repair it. It can be replaced, if you can get the part. HP have long since stopped supplying them. It is the same part in all Thinkjets apart from the one built into the Integral (this uses a longer flexible PCB).

If you have some other fault, let me (or the forum) know what it is, and I'll try to help.


Re: ThinkJet Priner Problems - Mike - 05-17-2006

That's probably it then. Yes, everything works right... print head goes through the motions but nothing happens. About 50% of the ones I have tested have this problem. It's either nothing at all or works fine. No in between.

Thanks, I'll tear one apart tonight and take a look.