HP Forums
HP-41C non working - Printable Version

+- HP Forums (https://archived.hpcalc.org/museumforum)
+-- Forum: HP Museum Forums (https://archived.hpcalc.org/museumforum/forum-1.html)
+--- Forum: Old HP Forum Archives (https://archived.hpcalc.org/museumforum/forum-2.html)
+--- Thread: HP-41C non working (/thread-75048.html)



HP-41C non working - Pelopi - 06-14-2005

During last months I have collected some "scrap". I have four HP-41C calculators. One of them works just fine. I can´t turn on the other three. I have tried to swap the CPUs. The result is that the working CPU is ok in any case and the other three don´t work anywhere. So it is clear that the problem is the CPU, not contacts or displays. Any ideas?. May be there is a capacitor or something that fails in this model.
Sorry for my bad english, I hope you understand me.

Thanks in advance


Re: HP-41C non working - Artur-Brazil - 06-14-2005

Hi, why you don't try to exchange the memory ICs from one to another?
Best regards
Artur


Re: HP-41C non working - Raymond Del Tondo - 06-14-2005

Hi,

I've seen several malfunctional HP-41 CPU boards.

In most cases so far there were one or more defective memory chips,

in two or three cases a bad ROM chip.

Remarkable is that it always was ROM 1,

or in other words, the second ROM chip.

Too bad one of the boards with a bad ROM chip is a CX:-(

Best Regards

Raymond


Re: HP-41C non working - David Smith - 06-15-2005

Clean the circuit board very thoroughly with 91%+ isopropyl alcohol. Very often several of the chips were hand soldered down and the old solder flux residue causes problems.