back of my hp 12c is bent - Printable Version +- HP Forums (https://archived.hpcalc.org/museumforum) +-- Forum: HP Museum Forums (https://archived.hpcalc.org/museumforum/forum-1.html) +--- Forum: Old HP Forum Archives (https://archived.hpcalc.org/museumforum/forum-2.html) +--- Thread: back of my hp 12c is bent (/thread-63477.html) |
back of my hp 12c is bent - Archie - 09-27-2004 Anyone have any experience removing/replacing the back metal plate on an HP 12c? The plate is bent outward and I'd like to take it off, straighten it and place it back on. Thanks!
Archie
Re: back of my hp 12c is bent - Thibaut.be - 09-27-2004 Try with a hairdryer and a sharp knife... but it will be difficult to get as nice as the original... in other words, do this if you really have to remove it.
Re: back of my hp 12c is bent - bill platt - 09-27-2004 I went through this with a 15c. It was not easy.
See Randy Sloyer's post in response to mine-----it was a yeer or more back---I'll look for it later in the archives.
bill
Re: back of my hp 12c is bent - bill platt - 09-27-2004 http://www.hpmuseum.org/cgi-sys/cgiwrap/hpmuseum/archv013.cgi?read=42223
Re: back of my hp 12c is bent - Thibaut.be - 09-27-2004 Never repaired a voyager's back plate, but well on a 67, and was very patient. It worked quite well with very little wrinkles, but still one cane notice that it had been unglued and re-glued.
|