+- HP Forums (https://archived.hpcalc.org/museumforum)
+-- Forum: HP Museum Forums (https://archived.hpcalc.org/museumforum/forum-1.html)
+--- Forum: Old HP Forum Archives (https://archived.hpcalc.org/museumforum/forum-2.html)
+--- Thread: HP Prime - Geometry App Intersection (/thread-255351.html)
HP Prime - Geometry App Intersection - bluesun08 - 11-09-2013
What is the difference in between "Point -> Intersection" and "Point -> More -> Intersections" in the geometry app (plot-view)?
Re: HP Prime - Geometry App Intersection - parisse - 11-10-2013
Most probably one menuitem returns the command for a single intersection point (single_inter), the other one a list of intersection points (inter).
Re: HP Prime - Geometry App Intersection - bluesun08 - 11-10-2013
1.
Sorry, but when i construct to lines with one intersection point, an choose "Point -> Intersection" and choose one after another line then it constructs no intersection point . Where i have made an mistake? Can you describe me the procedure (not mentioned in manual).
2.
When i construct the midpoint C between to points A and B then the "Enter"-key normally show me the list of points for choosing. But in this list there are only the point A and B. But not the point C. Why?