+- HP Forums (https://archived.hpcalc.org/museumforum)
+-- Forum: HP Museum Forums (https://archived.hpcalc.org/museumforum/forum-1.html)
+--- Forum: Old HP Forum Archives (https://archived.hpcalc.org/museumforum/forum-2.html)
+--- Thread: Sending ASCII Characters from or to the PRIME (/thread-253148.html)
Sending ASCII Characters from or to the PRIME - Harold A Climer - 10-18-2013
I was reading that the PRIME can act as USB host or client. Is it possible to send ASCII code to and from the calculator?
We are having a Fall break at UTC on Monday and Tuesday of next week
and I do not have any classes to teach until Thursday so I am going to try to hook up the Prime as well as my HP50G to a Vernier LabPro interface at school. The interface has both Serial and USB connectors. Note: I have used with a USB connection and a serial connection with a computer a they talk OK with either connection.
I think that the 50G will only work using a serial connection.
Re: Sending ASCII Characters from or to the PRIME - Tim Wessman - 10-18-2013
There is currently no way to do anything with the port. While the host driver does support HID, it does not allow any device except a ss410, wireless dongle, or another Prime calculator to be connected and initialized.
TW
Re: Sending ASCII Characters from or to the PRIME - CompSystems - 10-18-2013
on the board of the following image, I see two pins UART RX-TX, it is possible to create an inteface RS232 to connect with another device