HP Forums
wp34s calc to calc communication - Printable Version

+- HP Forums (https://archived.hpcalc.org/museumforum)
+-- Forum: HP Museum Forums (https://archived.hpcalc.org/museumforum/forum-1.html)
+--- Forum: Old HP Forum Archives (https://archived.hpcalc.org/museumforum/forum-2.html)
+--- Thread: wp34s calc to calc communication (/thread-247299.html)



wp34s calc to calc communication - Andrew Nikitin - 07-28-2013

I want to try wire a barrel 2.5 mm connector to tx, rx and ground of a wp34s and then use crossover cable (casio calcs uses 2.5mm crossover cable for their calc communications, so I do not need to make a cable, i can use that one) to try to communicate with SENDP/RECV or the likes.

Will that approach work? Did somebody already try that?

Edit:
Found
Marcus' thread. I guess, this answers my question.

Edited: 28 July 2013, 10:32 p.m.


Re: wp34s calc to calc communication - Marcus von Cube, Germany - 07-29-2013

The communication commands in WP 34S are designed for direct communication. Good luck!