+- HP Forums (https://archived.hpcalc.org/museumforum)
+-- Forum: HP Museum Forums (https://archived.hpcalc.org/museumforum/forum-1.html)
+--- Forum: Old HP Forum Archives (https://archived.hpcalc.org/museumforum/forum-2.html)
+--- Thread: Trouble entering a HP35s program line (/thread-241667.html)
Trouble entering a HP35s program line - Arno - 04-05-2013
Hello,
I hope someone can help me out with this. I found a very useful cashflow program here on the forum http://www.hpmuseum.org/cgi-sys/cgiwrap/hpmuseum/articles.cgi?read=896 but I am struggling with entering the following.
The link lists
C013 EQN CF0,CF1, ,CFN
How do I enter this correctly? I tried doing it by pressing the EQN button and my program line looks like this:
C013 CF0,CF1, ,CFN
However the program runs until this point and stops so I assume this is incorrect. What do I have to do to enter it correctly and display it as
C013 EQN CF0,CF1, ,CFN
Any help will be greatly appreciated.
Edited: 5 Apr 2013, 4:51 p.m.
Re: Trouble entering a HP35s program line - Andrew Feist - 04-05-2013
The SF10 in the program causes the machine to display equations, rather than evaluate them. So you should see "CF0,CF1,,CFN" on the top line of your display.
The stopping comes from the line that says "STOP" which (surprisingly) causes the program to stop.
The idea here is that you are given a prompt: Enter CF0, CF1, ..., CFN, pressing R/S (run/stop) after each one.
[If you want to look in the manual, stop is on page 13-19 and SF10 is on page 14-11.]
Re: Trouble entering a HP35s program line - Arno - 04-05-2013
Thank you so much. I understand the program better now and got it actually working.
Have a good weekend!