HP Forums
(deleted post) - Printable Version

+- HP Forums (https://archived.hpcalc.org/museumforum)
+-- Forum: HP Museum Forums (https://archived.hpcalc.org/museumforum/forum-1.html)
+--- Forum: Old HP Forum Archives (https://archived.hpcalc.org/museumforum/forum-2.html)
+--- Thread: (deleted post) (/thread-210146.html)



(deleted post) - deleted - 01-26-2012

This Message was deleted. This empty message preserves the threading when a post with followup(s) is deleted. If all followups have been removed, the original poster may delete this post again to make this placeholder disappear.


Re: [41CL] Ram - Monte Dalrymple - 01-27-2012

The starting address of RAM is 0x800000, but RAM below 0x804FFF is reserved for system use (the 41C register memory and the MMU entries). The memory from 0x805000 to 0x805FFF is the Y-functions buffer area, which can be used if you're not using the YBUILD command. The 58 pages starting at 0x806000 are available for any use.

Monte


(deleted post) - deleted - 01-27-2012

This Message was deleted. This empty message preserves the threading when a post with followup(s) is deleted. If all followups have been removed, the original poster may delete this post again to make this placeholder disappear.


Re: [41CL] Ram - Monte Dalrymple - 01-27-2012

Yes, you can use any address in the range.


The page orientation is only used with YMCPY.

Monte