+- HP Forums (https://archived.hpcalc.org/museumforum)
+-- Forum: HP Museum Forums (https://archived.hpcalc.org/museumforum/forum-1.html)
+--- Forum: Old HP Forum Archives (https://archived.hpcalc.org/museumforum/forum-2.html)
+--- Thread: Board Stacking Connector HP-9815 (/thread-187629.html)
Board Stacking Connector HP-9815 - aj04062 - 07-13-2011
Anyone know a source for new PCA stacking connectors?
Original is a Teledyne Interconnect 40 pin connector with .100" spacing. The part number is B415U040.
Anyone fixed busted contacts on these before?
Re: Board Stacking Connector HP-9815 - Joel Setton (France) - 07-14-2011
I haven't seen them anyplace but in a 9815. Must have been one of these special, non-standard things that were typical HP fashion.
I did kludge one by splitting a standard PC-edge connector along its length, then gluing the two halves back-to-back with epoxy. After that, a little dose of point-to-point soldering to bridge the contacts did the trick. It didn't look good but it got the calculator to work!
Joel
Re: Board Stacking Connector HP-9815 - aj04062 - 07-15-2011
For what it's worth, I found out the Teledyne still makes these contacts and sells them for $13 each.
TELEDYNE IMPULSE
9855 Carroll Canyon Road
San Diego CA 92131-1103
Phone 858 842-3138
Fax. 858 565-1649
TKC Product Line. Catalog here