HP Forums
HP65 in Nonpareil - Printable Version

+- HP Forums (https://archived.hpcalc.org/museumforum)
+-- Forum: HP Museum Forums (https://archived.hpcalc.org/museumforum/forum-1.html)
+--- Forum: Old HP Forum Archives (https://archived.hpcalc.org/museumforum/forum-2.html)
+--- Thread: HP65 in Nonpareil (/thread-177756.html)



HP65 in Nonpareil - Harald - 01-27-2011

On Eric Smiths website http://nonpareil.brouhaha.com/ it looks like Nonpareil includes the HP65. I have now installed v0.79, but that doesn't include the HP65. Is that in a seperate package? And if so, where can I find that?

Thanks,
Harald


Re: HP65 in Nonpareil - Eric Smith - 01-27-2011

The HP-65 is not supported. As the text immediately above the table states, only the models shown with a bullet are supported.

I've been working on support for additional models, and various other improvements, for a long time. Unfortunately I have relatively little time to spend on it.


Re: HP65 in Nonpareil - Harald - 01-28-2011

Quote:
The HP-65 is not supported. As the text immediately above the table states, only the models shown with a bullet are supported.

Oops, my mistake. I saw the picture of the HP-65 just above that and therefore assumed it would be supported. Perhaps I should have read the text, too :)

Quote:
I've been working on support for additional models, and various other improvements, for a long time. Unfortunately I have relatively little time to spend on it.

Well, can't have been that little time, considering what you have achieved already. Thanks for making this available to everyone!




Re: HP65 in Nonpareil - Gene Wright - 01-28-2011

What picture of the HP 65? I don't see one on the site... ?


Re: HP65 in Nonpareil - Harald - 01-28-2011

Hmm, good question, I am sure I saw that somewhere. But you are right, it isn't there.... So probably I am blind as well as dyslexic ;)