+- HP Forums (https://archived.hpcalc.org/museumforum)
+-- Forum: HP Museum Forums (https://archived.hpcalc.org/museumforum/forum-1.html)
+--- Forum: Old HP Forum Archives (https://archived.hpcalc.org/museumforum/forum-2.html)
+--- Thread: decimal point (/thread-174359.html)
decimal point - budlor - 11-06-2010
how do I set the decimal point so that all my calculations are set to 2 places following the decimal? What I'm looking for is the answer to be like this 0.00. I had this setting but I just changed the batteries and I can't remember how to set it. I can't find my manual. Thank you
Re: decimal point - Jim Yohe - 11-06-2010
I think that would depend on the model of calculator you're using.
For my 32SII:
DISP
FX
2
(note: no other keys necessary to end sequence)
For my 30B:
MODE
2
INPUT
ON/CE
(note: INPUT necessary to establish number of digits and ON/CE to exit MODE)
Re: decimal point - Martin Pinckney - 11-07-2010
1. On many smaller HP's it would be MODES (or DISP) FIX 2.
2. Except with some FIX is a shifted key, so you don't have to press MODES or DISP first.
3. On many RPL graphing calcs it would be true postfix notation: MODE 2 FIX.
4. Unless it's an algebraic graphing calc, then it might be MODES enter 2 on FIX line then ENTER.
Re: decimal point - Jim Yohe - 11-07-2010
It would have been simpler if you would have said which model of calculator you had since we are just "guessing" without knowing which steps you need to take to fix your two decimal places. ;-)