HP Forums
Faceplate separation repair - Printable Version

+- HP Forums (https://archived.hpcalc.org/museumforum)
+-- Forum: HP Museum Forums (https://archived.hpcalc.org/museumforum/forum-1.html)
+--- Forum: Old HP Forum Archives (https://archived.hpcalc.org/museumforum/forum-2.html)
+--- Thread: Faceplate separation repair (/thread-174034.html)

Faceplate separation repair - Jim Yohe - 10-30-2010

For a long time now my 32SII metal faceplate has been separating away from the plastic body ... right up near the top by the display.

Is there a particular glue (I assume) and method I should use to correct this? Also, I should "try" get something back in there and pull away the lint and stuff from behind it first. How might I do that? Seems a cotton swab would be too large.

Sorry if this has been covered before but I didn't have any luck with my search terms for a similar post and solution.

Re: Faceplate separation repair - Geoff Quickfall - 10-30-2010

check out HPSolve, June 2010:

June 2010

The second half of the restoration article explains the faceplate removal and glueing procedure.

I suggest you remove the faceplate, depending on how much has separated, as that way you can put a reverse curve on it so that it glues back to the case with the corners down. If the raised edges are not to great then a fine paint brush and contact cement will work. Make sure to press the glue joint for a few minutes to ensure it does not raise.

Cheers, Geoff

Re: Faceplate separation repair - Jim Yohe - 10-30-2010

Thank you for your input on this Geoff. I'm downloading the newsletter now and will look at it.


Perhaps I should just try using a fine paint brush to clean out the dust, then contact cement applied with the toothpicks first to see if I can get it to stay down. It's not raised any further back than to the bottom of the LCD display.

Edited: 30 Oct 2010, 10:25 p.m.

Re: Faceplate separation repair - Walter B - 10-31-2010

Hi Geoff,

let me take the opportunity and ask about your book: When will it be available? What will it cost? Or is it on the market already?

TIA for your response,