+- HP Forums (https://archived.hpcalc.org/museumforum)
+-- Forum: HP Museum Forums (https://archived.hpcalc.org/museumforum/forum-1.html)
+--- Forum: Old HP Forum Archives (https://archived.hpcalc.org/museumforum/forum-2.html)
+--- Thread: Dosbox + EMU41 problem (/thread-160184.html)
Dosbox + EMU41 problem - Geir Isene - 11-29-2009
Running EMU41 in Dosbox under Ubuntu 09.04:
It starts and after about two seconds, on top of the bottom part (the f1 - f12 buttons) it prints out the content of the Mcode registers and on the last line it prompts "Cmd: " and with a blinking cursor.
Any takers?
Re: Dosbox + EMU41 problem - Marcus von Cube, Germany - 11-29-2009
A "secret" debugger?
Re: Dosbox + EMU41 problem - Egan Ford - 11-29-2009
Nothing secret about it. It's in the EMU41 docs. Run 'emu41 /d' to get to the debugger. The prompt is 'Cmd:'. CTRL-Z from EMU41 will also dump you into the debugger. Perhaps you pressed CTRL-Z to background DOSBox but had the focus on DOSBox.
This is unrelated to DOSBox. IIRC, corrupt ROM images can also dump you into the EMU41 debugger. Try a fresh install of EMU41.
Edited: 29 Nov 2009, 8:21 p.m.
Re: Dosbox + EMU41 problem - Geir Isene - 11-30-2009
Quote:
This is unrelated to DOSBox. IIRC, corrupt ROM images can also dump you into the EMU41 debugger. Try a fresh install of EMU41.
That fixed it. Thanks.