HP Forums
HP 35s question - Printable Version

+- HP Forums (https://archived.hpcalc.org/museumforum)
+-- Forum: HP Museum Forums (https://archived.hpcalc.org/museumforum/forum-1.html)
+--- Forum: Old HP Forum Archives (https://archived.hpcalc.org/museumforum/forum-2.html)
+--- Thread: HP 35s question (/thread-127172.html)



HP 35s question - Bill Colisch - 10-21-2007

Is it possible to recall from the stack (RCL stack T, Z, Y)?

Thanks for your help.

Bill :-)


Re: HP 35s question - Meenzer - 10-22-2007

While programming (ALG, RPN), just use the "R down" key and you'll be presented with a choice for X, Y, Z and T. Use left and right arrows and ENTER to choose. In RPN calculator mode you only have "R down". In ALG you'll see the X,Y,Z and T choice after pressing "R down".


Edited: 22 Oct 2007, 5:09 a.m.


Re: HP 35s question - Stefan Vorkoetter - 10-22-2007

If I remember correctly (my 35s isn't in front of me at the moment), in RPN mode, press any key that brings up a menu (e.g. Flags) and then press RollDown, and you'll get a menu of stack registers. Pressing one recalls that register (or inserts a REG_ instruction if you're in PRGM mode).

Stefan


Re: HP 35s question - Miguel Toro - 10-22-2007

In RPN, if you are in PRGM mode this method allows to review the stack content and insert a REG_ instruction without needing to press the EQN key. In RUN mode, it only allows to review the content of the stack, not to recall the values, unfortunately.

Look at this link for more details.

Regards,

Miguel




Re: HP 35s question - Bill Colisch - 10-22-2007

Thanks to all, that did it.

Bill :-)