+- HP Forums (https://archived.hpcalc.org/museumforum)
+-- Forum: HP Museum Forums (https://archived.hpcalc.org/museumforum/forum-1.html)
+--- Forum: Old HP Forum Archives (https://archived.hpcalc.org/museumforum/forum-2.html)
+--- Thread: How to control the recieve bit in the HP48 as an input bit... (/thread-12688.html)
How to control the recieve bit in the HP48 as an input bit... - tal - 11-18-2001
Hi, HP48 users!
Several months ago I built a data logger for HP48.
Since there is no availability of A/D converter to RS232
I had to build a "UART" (a parallel to serial converter),
and to use a parallel A/D.
Today some of my friends (a TI89 user) showed me a very
simple project (more so then mine) that does the same thing.
The site address is http://www.dvz.fh-koeln.de/~b012414/osci89/osci.html
I wonder how to control the recieve bit in the HP48 as an input bit
without using the RS232 protocol, (the transmit bit controlled by
the "OPENIO" and "CLOSEIO" comands.
I would be very thankful if you could help me and I hope its
not too difficult of a task for you.
Best regards,
Tal.
email: td@chem.ch.huji.ac.il
Re: How to control the recieve bit in the HP48 as an input bit... - Vieira, Luiz C. (Brazil) - 11-18-2001
Hello;
I`m not sure you'll have access to the receive bit (do you mean Start bit, from Start/Stop?), but there are two commands that allow you to send and receive data without using Kermit: XMIT and SRECV. Both (counterparts) receive/send data through serial port. See AUG, 3-318 (SRECV) and 3-381 (XMIT).
Hope it helps.
Cheers.